5 FRONT RIGGINGS
5.4Installing/Removing Elevating Legrest Assembly
Installing
1.Place elevating legrest assembly on the outside of the wheelchair and install the hinge plates onto the hinge pins on the wheelchair frame.
2.Rotate elevating legrest assembly toward the inside of the wheelchair until it locks in place.
3.Repeat this procedure for other legrest assembly.
The footplates will be facing each other when locked in place.
Step 1
Bolt and Locknut
Calfpad Assembly
Lower Footrest Assembly
Footplate
4.After seated in wheelchair, adjust the legrest to correct height. Refer to Installing/Removing Elevating Legrest Assembly on page 37.
Removing
1.To release the elevating legrest assembly, push the legrest release handle toward the inside of the wheelchair (facing the front of the wheelchair) and swing the legrest assembly to the outside of the wheelchair.
2.Lift the elevating legrest assembly off of the hinge pins.
Steps 2 & 3
Hinge Plates
Elevating Legrest
Assembly
Hinge Pins 
Legrest Release
Handle
|
| | |
|
|
| J934A installs the same way. |
|
| FIGURE 4 Installing/Removing Elevating Legrest Assembly | |
Part No 1100868 | 37 | Invacare® Jymni™ Pediatric Series Wheelchair | |
