5FRONT RIGGINGS
5.3Heel Loop Replacement
Swingaway Footrests/Elevating Legrest (J932A,
1.Remove the four mounting screws and washers that secure the heel loop to the BOTTOM of the footrest.
2.Remove the heel loop from the footrest.
3.Position the new heel loop as shown in FIGURE 3 and reverse STEPS
Elevating Legrest (J934A-14 ONLY)
1.Loosen, but do not remove the bolt and locknut that secure the lower half of the footrest to the swingaway footrest assembly.
2.Remove the lower footrest assembly.
3.Remove the mounting screw and locknut that secure the heel loop to the footrest.
4.Slide heel loop over cane of the footrest assembly.
5.Replace heel loop.
6.Reverse STEPS
When securing the heel loop to the footrest assembly, tighten the mounting screw and locknut until the spacer is secure.
JA932A, | Mounting Screw | Bolt and Locknut | |
| |||
| |||
|
| ||
J933A, J934A |
| Heel Loop | |
| Spacer | ||
|
| ||
Footrest | Heel Loop | Cane | |
| |||
| |||
Washer |
| ||
|
| ||
Mounting Screw |
| Lower Footrest | |
| Locknut | Assembly | |
|
| ||
FIGURE 3 Adjusting the Elevating Legrest Assembly |
| ||
Invacare® Jymni™ Pediatric Series Wheelchair | 36 | Part No 1100868 |