Invacare IIBASIC, IIJR manual Battery Tray, Front Hex ScrewFootboard Pivot Caplug Assemblies Washer

FRONT RIGGINGS PROCEDURE 3

ADJUSTING FOOTBOARD MOUNTING BRACKET ANGLE - FWD MODELS ONLY (FIGURE 10).

NOTE: This procedure applies to FWD wheelchair mod- els only.

NOTE: Angle availability is limited when the motors are in the forward-most position.

1.Remove the caplug cap.

2.Remove the front hex screw and caplug washer that secure the footboard mounting bracket and bushing to the wheelchair.

3.Repeat STEPS 1-2 for the opposite footboard mount- ing bracket.

4.Move the footboard mounting brackets to one (1) of three (3) positions.

NOTE: To ensure the existing hex screws tighten securely, apply Loctite 242 onto the threads.

5.Reinstall the two (2) hex screws and caplug washers through the two (2) footboard mounting brackets and bushings and into the wheelchair.

6.Torque the two (2) hex screws to 13-ft/lbs.

7.Reinstall the two (2) caplug caps.

FWD WHEELCHAIRS ONLY

Battery

Tray

3 Mounting
Positions	Bushing
Caplug	Footboard
Cap
	Mounting
	Bracket

Front Hex

ScrewFootboard

Pivot

Caplug

Assemblies

Washer

FIGURE 10 - ADJUSTING

REMOVABLE FOOTBOARD - ADJUSTING FOOTBOARD MOUNTING BRACKET ANGLE

ADJUSTING THE REMOVABLE FOOTBOARD HEIGHT (FIGURE 11)

1.Remove the removable footboard plate. Refer to

REMOVING/INSTALLING THE REMOVABLE FOOTBOARD ONTO/FROM THE WHEELCHAIR in PROCEDURE 3 of the Owner’s Manual.

2.Remove the caplug cap.

3.Remove the mounting screw, caplug washer, flat washer and nut that secures the two (2) large wash- ers and support tube to the height adjustment bracket and footboard bracket. Refer to DETAIL “A”.

4.Remove the nut, flat washer and that secure the threaded arm on the height adjustment bracket to the footboard bracket. Refer to DETAIL “B”.

5.Perform one (1) of the following:

A.MWD WHEELCHAIRS - Move the height ad- justment bracket to one (1) of seven (7) height positions.

B.FWD WHEELCHAIRS - Move the height ad- justment bracket to one (1) of five (5) height positions.

6.Reinstall the flat washer and nut that secures the threaded arm on the height adjustment bracket to the footboard bracket. Refer to DETAIL “B”.

7.Reinstall the mounting screw, caplug washer, flat washer and nut that secures the two (2) large wash- ers and support tube to the height adjustment bracket and footboard bracket. Refer to DETAIL “A”.

8.Reinstall the caplug caps.

9.Repeat STEPS 2-8 for the opposite footboard bracket.

10.Reinstall the removable footboard plate. Refer to

REMOVING/INSTALLING THE REMOVABLE FOOTBOARD ONTO/FROM THE WHEELCHAIR in PROCEDURE 3 of the Owner’s Manual.

F R O N T

R

I

G G I N G S

25