FWD WHEELCHAIRS | PROCEDURE 11 | |
|
|
|
8.Feed the retaining strap through the slot located on the top of the rear shroud.
9.Bundle excess joystick cable and tie wrap together. See DETAIL "A".
10.Positionbundledjoystickcablebetweenretainingstrap and rear battery box. See DETAIL "A".
11.Clip the retaining strap together to secure the rear shroud and battery box in place.
12.Press down on the rear shroud until the two (2) clips secure the rear shroud to the two side shrouds.
13.Connect the battery leads from the battery boxes to the battery connectors on the wheelchair frame.
14.If necessary, install the Captain's Seat. Refer to RE- MOVING/INSTALLINGCAPTAIN'SSEATinPROCE- DURE 5 of this manual.
15.If necessary, reinstall the removeable footboard. Refer to PREPARING THE REMOVEABLE FOOTBOARD FOR WHEELCHAIR TRANSPOR- TATION in PROCEDURE 3 of this manual.
Joystick Cable | DETAIL "A" |
| |
| Rear Battery |
| Box |
Strap
Retaining | Retaining | |
Strap | Strap Clip | |
Rear | Front | |
Battery | Battery Box | |
Box |
| |
Battery | Front of the | |
Wheelchair | ||
Tray | ||
| ||
Battery Connections on |
| |
Side of Wheelchair Frame |
|
NOTE: Wheelchair Frame not shown for clarity.
FIGURE 5 - INSTALLING/REMOVING BATTERY BOXES
ALL MODELS EXCEPT RANGER IIJR
RANGER IIJR (FIGURE 6).
1.Verify that the ON/OFF switch on the joystick is in the OFF position.
2.If necessary, remove the front and rear shrouds. Refer to REMOVING/INSTALLING SHROUDSin PROCE- DURE 9 of this manual.
NOTE: Make sure the battery cables on the battery boxes are on the same side as the battery connectors on the wheelchair frame.
WARNING
The battery connector on the front battery box MUST be connected to the wiring harness be- fore placing front battery on battery tray. Oth- erwise, injury may result.
3.Connect the battery cables from the front battery box to the battery connectors on the wheelchair frame.
4.Position the front battery box onto the battery tray as shown in FIGURE 6.
5.Feed the front retaining strap through the slot located on the top of the front shroud.
6.Position the bottom of the front shroud
7.Clip the front retaining strap together.
8.Pull end of retaining strap to secure front battery box and front shroud in place.
9.Position the rear battery box onto the battery tray as shown in FIGURE 6.
10.Connect the battery cable from the rear battery box to the rear battery connectors on the wheelchair frame.
11.Bundle excess joystick cable and tie wrap together. See DETAIL "A".
12.Position excess joystick cable between retaining strap and rear battery box. See DETAIL "A".
13.Clip the rear retaining strap together.
14.Pull end of retaining strap to secure battery box and joystick in place.
15.Installtherearshroud.Referto REMOVING/INSTALL- ING SHROUDS in PROCEDURE 9 of this manual.
16.If necessary, reinstall the removeable footboard. Refer to PREPARING THE REMOVEABLE FOOTBOARD FOR WHEELCHAIR TRANSPOR- TATION in PROCEDURE 3 of this manual.
F
W D
W H E E L C H A I R S
51
