Invacare II250 SERIES, IIJR, IIBASIC manual Raising/Lowering Elevating Legrests, Adjusting Calfpads

FRONT RIGGINGS PROCEDURE 3

RAISING/LOWERING ELEVATING LEGRESTS AND/OR ADJUSTING CALFPADS (FIGURE 6)

Raising/Lowering Elevating Legrests

1.Perform one (1) of the following:

RAISING - Pull back on the release lever

until the leg is at the desired height.

LOWERING - Support leg with one (1) hand and push release lever down- ward with other hand.

Adjusting Calfpads

1.Turn calfpad towards the outside of the wheelchair.

2.Slide the calfpad up or down until the desired position is obtained.

NOTE: If one (1) of the top two (2) calfpad adjustment positions is being used, the legrest will need to be raised to avoid interference with the front stabilizers while going over obstacles or going up and down ramps. Refer to RAISING/LOWERING ELEVATING LEGRESTS in this procedure of the manual.

3. Turn the calfpad towards the inside of the wheelchair.

Release Lever

Calfpad

Rotated for

Height

Adjustment

Calfpad

Top Two (2) Calfpad

Adjustment Positions

FIGURE 6- RAISING/LOWERING ELEVATING LEGRESTS AND/OR ADJUSTING CALFPADS

ADJUSTING/REPLACING TELESCOPING FRONT RIGGING SUPPORT (FIGURE 7)

1.Lift up on the crossbraces until they release from the H-blocks on the wheelchair frame.

2.Remove the phillips bolt and locknut that secure the front H-block to the wheelchair frame.

3.Remove the two (2) locknuts and socket bolts that secure telescoping front rigging support to wheelchair.

4.If necessary, remove the hex bolt and locknut that secures the battery charger connector bracket to the wheelchair.

Adjusting

1.Position the telescoping front rigging support to the desired depth.

NOTE: The footplate will be on the inside of the wheel- chair when locked in place.

2.Insertfrontsocketboltintowheelchairframeandmount- ing hole in the telescoping front rigging support deter- mined in STEP 1 and securely tighten with the locknut.

3.Insert the rear socket bolt through the wheelchair frame and the telescoping front rigging support and securely tighten with the locknut.

4.Resecure the front H-block to the wheelchair with the phillips bolt and locknut.

5.If necessary, resecure the battery charger con- nector bracket to the wheelchair with the two (2) hex bolts and locknuts.

6.Snap crossbraces into H-blocks. Wiggle crossbraces to make sure they are secured in the H-blocks.

Phillips Bolt
H-Block	FRONT SOCKET BOLT
	POSITIONS (IN
Front Socket Bolt	INCHES DEEP):
Rear	16
Socket Bolt	18 and
	17

Wheelchair

Frame

Locknuts

DO NOT USE WITH FRONT	Telescoping
SOCKET BOLT	Front Rigging
Hex Bolt and	Support
Locknut

Battery

Charger

Bracket

FIGURE 7 - ADJUSTING/REPLACING TELESCOPING

FRONT RIGGING SUPPORT

F R O N T

R

I

G G I N G S

23