Invacare Pronto M91 Base manual Display Description Definition, Possible Solution

SECTION 4—SAFETY INSPECTION/TROUBLESHOOTING

Information Gauge Display Diagnostics

DISPLAY DESCRIPTION DEFINITION COMMENTS

Information

Gauge

Display

All LEDs are off. Power is off.

	All LEDs are on.		Power is on.	Fewer than three LEDs on
				implies reduced battery
				charge.
	Left RED LED is flashing.		Battery charge is low.	The batteries should be
				charged as soon as
				possible.
	Left to Right “chase”		Joystick is in	The steady LEDs indicate
	alternating with steady		programming, inhibit and/	the current state of the
	display.		or charging mode.	battery charge.
	All LEDs are flashing slowly.		Joystick has detected Out-	Release the joystick back
			of-Neutral-at-Power-Up	to Neutral.
			mode.
Service Indicator Light Diagnostics
NUMBER	ERROR CODE
OF			POSSIBLE SOLUTION
	DESCRIPTION
FLASHES
1	User Fault	Release joystick to neutral and try again.
2	Battery Fault	Charge the batteries. Refer to Charging Batteries on page 63.
		Check that battery cables are connected properly. Refer to Connecting/
		Disconnecting the Battery Wiring Harness on page 60.
		If necessary, replace batteries. Refer to Installing/Removing the Batteries
		on page 57.
3	Left Motor Fault	Contact Invacare/Dealer for service.
4	Right Motor Fault	Contact Invacare/Dealer for service.
5	Left Park Brake Fault	Contact Invacare/Dealer for service.
6	Right Park Brake Fault	Contact Invacare/Dealer for service.
7	Remote Fault	Check to make sure joystick is connected properly.
		Contact Invacare/Dealer for service.
8	Controller Fault	Contact Invacare/Dealer for service.
9	Communications Fault	Contact Invacare/Dealer for service.
10	General Fault	Contact Invacare/Dealer for service.
11	Incompatible or	Wrong type of remote connected. Contact Invacare/Dealer for service.
	incorrect Remote

Part No 1143153 29 Pronto® M91™Base with SureStep®