SECTION 5—WHEELCHAIR OPERATION

Mode Switch

NOTE: For this procedure, refer to FIGURE 5.4.

The mode switch is used to select the operating mode for the wheelchair. The mode switch is located on the joystick. A mode switch is needed whenever any of the following operating modes are programmed:

Environmental Controls (ECU 1, ECU 2, ECU 3, ECU 4)*

3 Speed Mode in Digital 3 Speed (Slow, Medium, Full)

Latched Modes

Sleep Mode

RIM Mode*

Remote Drive Selection Mode*

Tilt/Recline Mode*

Information Center Display Selection (does not require Reset activation at power up)

If any of the above modes are selected, the control will require activation of the switch immediately after the power switch is turned On in order to enter the drive mode. The second line of the LCD will display ‐ PRESS RESET.

*NOTE: In these modes, Standby Select allows the reset switch to be bypassed for users unable to activate the switch.

Memory Card Slot

The memory card slot is used with the basic or professional memory card for saving or reading wheelchair parameters.

Preparing the Joystick for Use

NOTE: For this procedure, refer to FIGURE 5.9.

NOTE: The joystick is factory installed on the right side of the wheelchair. To reposition the joystick onto the left side of the wheelchair, refer to Repositioning the Joystick on page 43.

1.

Turn the adjustment lock lever to

 

NOTE: Joystick

 

release the adjustment lock from

 

 

 

not shown.

 

joystick mounting tube.

 

 

 

 

2.

Slide joystick mounting tube to the

 

 

 

desired position.

 

 

3.

Turn the adjustment lock lever to

Joystick Mounting

 

 

secure the adjustment lock to the

Tube

Adjustment

 

 

 

joystick mounting tube.

 

Lock Lever

FIGURE 5.9 Preparing the Joystick for Use

Pronto® M91™Base with SureStep®

42

Part No 1143153

Page 42
Image 42
Invacare Pronto M91 Base manual Preparing the Joystick for Use, Mode Switch, Memory Card Slot