SECTION 9—BATTERIES

7.Reposition battery terminal covers over battery post(s).

8.Using new tie‐wraps, secure the terminal covers to the battery terminals as shown in FIGURE 9.3.

9.Repeat STEPS 1‐8 to install and connect the rear battery to the rear battery harness.

NEGATIVE (-)

 

 

POSITIVE (+)

Battery Cable

 

 

Battery Cable,

 

 

 

Mounting Screw with

NEGATIVE (-)

Nut

 

Fuse Hardware

Battery Terminal

 

 

 

 

Tie-Wrap

 

 

 

Mounting

 

 

 

Screw

 

 

 

 

 

 

Locknut

 

Tie-Wrap

 

 

 

 

Battery

POSITIVE (+)

 

 

Battery Terminal

 

 

 

FIGURE 9.3 Connecting/Disconnecting the Battery Wiring Harness

Disconnecting

NOTE: For this procedure, refer to FIGURE 9.3 on page 61.

1.Remove the existing tie‐wraps that secure the battery terminal covers to the battery terminals.

2.Peel back RED battery terminal cover to expose RED battery cable connection to battery terminal.

3.Peel back BLACK battery terminal cover from BLACK battery cable on front battery or GREY battery terminal cover from BLACK battery cable on rear battery.

4.Remove the mounting screws and nuts that secure the POSITIVE (+) RED battery cable to the POSITIVE (+) battery terminal/post as shown in FIGURE 9.3.

5.Remove the mounting screws and nuts that secure the NEGATIVE (‐) BLACK battery cable to the NEGATIVE (‐) battery terminal/post as shown in FIGURE 9.3.

6.Set wiring harness aside.

7.Repeat STEPS 1‐6 to disconnect the rear battery from the rear battery harness.

Part No 1143153

61

Pronto® M91™Base with SureStep®

Page 61
Image 61
Invacare Pronto M91 Base manual Connecting/Disconnecting the Battery Wiring Harness