SECTION 6—SEAT

Installing

1.Position the seat in the rear pivot brackets as shown in FIGURE 6.1.

2.Tilt front edge of seat down.

3.When seat is lowered, engage seat brackets into seat clevis pins.

WARNING

When reinstalling the seat verify that the seat brackets are engaged with the seat clevis pins by pulling up on the latch bar.

4.Pull up on latch bar to verify that brackets are engaged with seat clevis pins.

5.Connect the joystick. Refer to Disconnecting/Connecting the Joysticks on page 44.

Rear Pivot

Brackets

Seat Clevis Pins

NOTE: Van Seat model shown. Adjustable ASBA seat removes/ installs in the same way.

Latch Bar

(located under the front of the seat)

FIGURE 6.1 Removing/Installing the Seat Assembly

Tilting the Seat Assembly

NOTE: For this procedure, refer to FIGURE 6.2 on page 48.

NOTE: This procedure is for M91 wheelchairs with the Formula PTO Plus Seating System ONLY.

NOTE: Removing the seat is not necessary to access the battery compartment on wheelchairs equipped with a Formula PTO Plus seating system. The seat assembly with the Formula PTO Plus seating system tilts back and props into place to provide access to the batteries and the underside of the seat.

WARNING

Make sure power to the wheelchair is Off before performing this procedure.

Never leave the seat assembly in the up/open position unless necessary to perform a procedure on the wheelchair - otherwise injury or damage may result.

After ANY adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.

Part No 1143153

47

Pronto® M91™Base with SureStep®

Page 47
Image 47
Invacare Pronto M91 Base manual Tilting the Seat Assembly, Installing