Installation Guide | Iomega 03798300 manual

Installation Guide

2bIf the CD drive and hard drive are on different IDE

channels...

Follow the IDE interface cable to find out if the CD drive is the only device connected to the secondary IDE channel. If it is, see Installing the Zip Drive as the Slave Device starting on page 11 of this manual for instructions on installing your Zip® drive.

CD drive

IDE hard drive

IDE data cables that extend

to the motherboard

IDE Channels

2c If the CD drive and hard drive are on the same IDE

channel...

If the CD drive and the hard drive are both connected to the primary IDE channel, the secondary IDE channel should be unused, as shown in the following illustration. If your system has this configuration, see the section entitled Installing the Zip® drive as the only device on the secondary IDE channel starting on page 17 of this manual for instructions on installing your Zip® drive.

CD drive

IDE hard drive

IDE data cable that extends to the motherboard

IDE Channels

10

Image 10

Iomega 03798300 owner manual Installation Guide

Contents

Internal Atapi Drive Table of Contents Welcome to Zip Drive Check system requirements Unpack the Zip Internal Atapi drive Write down the serial number of your Zip Disconnect the computer power cordWatch the instructional video Internal Atapi drive for future reference Identifying the computer’s IDE configuration 1b Locate the IDE channels using the computer’s hard drive Identify your computer’s IDE configurationLocate the IDE channels using the CD drive Follow these instructions if you were unable to 1c Possible IDE channel locations Determining your computer’s configuration If the hard drive is the only IDE device connected Installation Guide Check the jumper setting on the Zip drive Panel cover Guide Remove the IDE Interface cable that is Slide the Zip drive into the drive bayCurrently connected to your CD drive Verify that the jumper on your CD drive is set to Master Cable to the Zip drive Connect an internal computer power supplySecure drive in drive bay Guide Change the jumper setting to Master Locate a vacant 31/2 or 51/4 drive bay May require side rails 2a3 1/2 drive bays only Print on one side of the data cable showing Locate the data cable that comes packagedWith the Zip drive. Find the colored stripe or PIN Zip drive Cable to your Zip drive Internal drive. M Guide Not start automatically, follow these steps If the Iomega software setup program doesCD drive Software Additional instructions for your system Windows 95/98 Users Create Install Floppy Diskettes How to Install Without a CD DriveDownload Software from the Iomega Web Site Installation Guide Operating Your Zip Drive Inserting Zip Disks Ejecting Zip Disks Disk Eject in Case of Power LossDrive Sleep Compatibility with 100MB Zip Disks Zip Tips Copy Machine Step Backup/RestoreRecordIt Software Iomega Tools For information on how to use IomegaWare software Drive Shortcuts Backing Up with Zip Disks Copying Zip Disks Formatting Zip Disks Installing Applications to Zip DisksFormatting Zip Disks under Windows 95/98 or NT Setting Zip Disk Protection under Windows 95/98 and NT Read/Write Protecting Zip Disks Jumper Settings What is IDE?What is ATAPI? How IDE Works Slave Drive Possible System IDE/ATAPI ConfigurationsBIOS/CMOS Support Master Drive Troubleshooting Green activity light on the Zip drive does not turn on Troubleshooting Data transfer problems or drive operation is erratic Installing the Zip drive changes other drive letters Windows 95/98 Users Troubleshooting You want to use Windows 95/98 DOS mode with your Zip drive How to Get Help Automated Voice Technical Support Automated FAX-back Help 801 778-5763 U.S. & Canada One-on-One Iomega Technical Support Product Information Limited Warranty InformationReturn or Repair International Support Numbers Canadian Verification Regulatory InformationModel Number Z250ATAPI FCC United States CE European Community Visit our web site