8 | Connect an internal computer power supply |
| |
| cable to the Zip® drive. |
| M NOTE: If the computer does not have a spare power supply |
| cable, use the power |
| the CD drive or another device (do not disconnect the power to the |
| hard drive) and connect the power |
| extensions of the power |
| and to the Zip® Internal drive. M |
Zip Internal drive
| Power Supply Cable | |
| from Computer | |
|
| |
| CAUTION | Make sure the power supply cable is securely connected to |
| the Zip® drive. M | |
9 | Secure drive in drive bay. | |
Align the front of the Zip® drive with other drives installed in the computer. | ||
If there is not clear access to the drive bay mounting holes, refer to your computer manual for additional instructions. Note that if the drive is held in place securely by rails, you will not need to use the mounting screws.
Installation Guide
Drive Bay
Mounting Screws 
CAUTION Mounting screws must not extend into the Zip® Internal drive farther than 4.0 mm (about 0.16 inch). Mounting screws that are too long could damage the drive. M
15
