Zip Internal drive
Jumper block
Slave (Drive 1) |
(Factory Setting) |
Master (Drive 0) 
Cable Select 
Reserved |
(do not use) |
Slave (Drive 1)
Use this setting if you’re connecting the Zip® Internal drive on the same cable as your CD drive or another ATAPI device that is configured as the master.
Master (Drive 0)
Use this setting if you’re connecting the Zip® Internal drive as the only device on the secondary IDE channel or when installing to an IDE
Cable Select
Use this jumper setting if your computer features “Cable Select.” On a
Cable Select system, the master/slave configuration is automatically determined by the system. Contact the computer manufacturer if you need additional information. Use the jumper provided when configuring the drive to the “Cable Select” setting.
Possible System IDE/ATAPI Configurations
Your computer may be configured in one of the following ways. If you need to change the jumper settings for your CD drive, check its documentation to see how to configure it as master or slave as needed.
(Recommended)
| Primary IDE | Secondary IDE | |
| Channel | Channel | |
Master | Hard Drive | CD drive | |
Device | |||
|
| ||
Slave |
| Zip ATAPI | |
Device |
| Drive |
User’s Guide
(Alternative)
| Primary IDE | Secondary IDE | |
| Channel | Channel | |
Master | Hard Drive | Zip ATAPI | |
Device | Drive | ||
| |||
Slave | CD drive |
| |
Device |
| ||
|
|
(Alternative)
| Primary IDE | Secondary IDE | |
| Channel | Channel | |
Master | Hard Drive | Zip ATAPI | |
Device | Drive | ||
| |||
Slave |
| CD drive | |
Device |
| ||
|
|
BIOS/CMOS Support
BIOS support for the Zip® Internal drive should be disabled in the CMOS Setup. If your system includes autodetection, it should be turned off for the Zip Internal drive.
37
