Installing the Zip® drive as the only device on the secondary IDE channel
| M IMPORTANT! The Zip® Internal drive uses the computer’s |
| onboard IDE/ATA interface. If you are not familiar with how devices |
| connect to the IDE interface, please see Understanding IDE |
| Connections on pages 36 and 37. M |
1 | Change the jumper setting to “Master”. |
The Zip Internal drive is set to the slave configuration as the factory default |
at shipping. In order to connect the Zip Internal drive as the only device on the secondary IDE channel, you will need to change the jumper setting on the drive. The jumper is a small plastic piece that surrounds two pins. Use the jumper provided and set it on the back of the Zip drive as shown in the illustration below.
Installation Guide
Jumper block 
Master (Drive 0) 
2 Locate a vacant 31/2” or 51/4” drive bay.
51/4" Bay
31/2" Bay
17
