Iomega 03798300 owner manual Verify that the jumper on your CD drive is set to Master

6

InstallationGuide

7

Verify that the jumper on your CD drive is set to “Master.”

In order for the CD drive and Zip® drive to work together properly, ensure that the jumper on the CD drive is set to the “master” setting. A chart indicating the jumper setting should be located on the CD drive. If you are unsure of the setting or how to change it, refer to the documentation that came with your CD drive or computer.

Connect the CD drive and the Zip® Internal drive to the motherboard.

Using the 40-pin IDE interface cable that is provided, connect the long end, or the end furthest from the middle connector on the cable, to the secondary IDE channel. Connect the middle connector to the CD drive and then connect the other end of the cable to the Zip® Internal drive.

CAUTION Make sure PIN 1 on the cable connects to PIN 1 on the Zip® Internal drive, the CD drive and the motherboard. All IDE interface cable connections must maintain correct PIN 1 orientation in order for the Zip® drive to be recognized by the system. M

Zip Internal drive

PIN 1

40-pin Interface Cable Connector Stripe on Interface Cable indicates PIN 1

The IDE interface cable can be connected from the secondary IDE channel to the CD drive and then to the Zip® drive, or it can be connected from the secondary IDE channel to the Zip drive and then to the CD drive. For information on possible IDE/ATAPI drive configurations for your computer, see Understanding IDE Connections on pages 36 and 37.

14