To Use Sabbath Mode:
The Sabbath Mode must be enabled each time it is used.
1.From the Setup Menu, scroll the bar until Sabbath Mode appears and touch SABBATH MODE.
2.From the Sabbath Mode Menu, read the
NOTE: Sabbath Mode disables the
3.On 48" [121.9 cm] ranges, select the oven to set up by pressing the Left Oven or Right Oven buttons.
4.Touch COOKING SETTING. To select the oven temperature, use the slider to enter a desired temperature or touch the
5.Press NEXT.
6.If desired, set the Cook Timer by using the
7.Press NEXT.
8.On 48" [121.9 cm] ranges, repeat steps
WARNING
Food Poisoning Hazard
Do not let food sit in oven more than one hour before or after cooking.
Doing so can result in food poisoning or sickness.
9.(Optional) To set a Delayed Start, touch DELAY START and set the desired time. See the “Delay Start” section for more information.
10.Press START to begin heating the oven.
11.Press CANCEL OVEN (CANCEL LEFT or CANCEL RIGHT on 48" [121.9 cm] models) to turn off the oven.
To Disable Sabbath Mode:
Sabbath Mode will automatically be disabled when a cook time ends, or can be disabled by pressing Cancel. “Sabbath Mode: OFF” will appear on screen. To program a new cycle, follow steps 2 - 11 in the “To Use Sabbath Mode” section.
To Change Temperature:
The oven temperature can be changed when the oven(s) are in the Sabbath Mode. No tones will sound, and the display will not change. Touch the
NOTE: On double ovens, if both ovens are operating in Sabbath Mode, the temperature of each oven can be changed independently. Touch the
Temperature Calibration
1.From the Setup Menu, touch TEMPERATURE CALIBRATION.
2.On 48" (121.9 cm) ranges, select which oven to calibrate by pressing LEFT OVEN or RIGHT OVEN.
3.Touch NEXT.
4.Select the temperature offset. Press
5.Touch SAVE and the adjustment has been made.
Touchscreen Calibration
IMPORTANT: If the buttons on the screen are difficult to touch accurately, you may need to calibrate the touchscreen.
1.From the Setup Menu, touch TOUCHSCREEN CALIBRATION.
2.Touch NEXT.
3.You will be asked to touch, hold and release 3 targets to calibrate.
4.You will be asked to again touch the same targets in
10 seconds. If calibration failed, it will restart the process at Step 2.
5.Test calibration by moving the circle around the screen. Ensure you can reach all the corners.
6.Touch TRY AGAIN to run calibration again.
7.If CANCEL is touched, the Touchscreen Calibration will be canceled.
8.Touch SAVE. This will return you to the Clock Screen.
Reset All Settings To Factory Defaults
1.From the Setup Menu, touch RESET ALL SETTINGS.
2.Touch RESET or CANCEL.
3.If Reset is touched, the following settings will be lost: most used modes, My Creations, Date/Time, and Language. The Welcome Guide will appear to help you reset these settings.
Service Information
For more information, see the “Assistance or Service” section.
1.From the Setup menu, touch SERVICE INFORMATION.
2.Choose ON or OFF for Demo Mode.
3.If CANCEL is touched, the Service Information will go back to the default setting.
4.Touch SAVE. This will return you to the Clock Screen.
16