Mounting the Left Extension Wing Assembly
Model LSB only
The left extension table, identified by the scale (B, Fig. 16) on the rail, is used only with model LSB The assembly and mounting procedure is the same manner as for the right extension wing (above).
Left Scale Extension
Model LSB only
Referring to Figures 16:
1.If necessary, loosen the extension table lock knobs and slide the extension table (D) flush against the saw table (E).
2.Take the left rail extension (A) identified by scale range
3.View from underneath and adjust until the two holes in the rail extension (A) and table rail (C) are aligned.
4.Insert two each M4x10 pan head screws (J), M4 lock washers (K) and M4 flat washers (L) to hold the extension rail in place, but leave loose enough to permit adjustment (following steps).
5.Place a scale or yardstick (F) across the extension table and saw table.
6.Align the 11" mark on the ruler (G1) with the 11" mark on the guide rail (G2) and hold ruler firmly in place while performing the next step.
7.Adjust the rail extension (A) until the 18" mark (H1) is aligned with the 18" mark on the ruler (H2). Release the ruler while making sure the rail extension does not move.
The left rail extension is now properly | Figure 16 |
calibrated. While holding it in place: |
|
8. Tighten the two screws (K). |
|
Right Scale Extension
Models BTC, LSA and LSB
The assembly steps are the same as for the Left Scale Extension. For the alignment, use 14" and 21" as the calibration marks.
16
