Jet Tools 708315BTA operating instructions Where to Begin, Leg Assembly, Models LSA, LSB

Assembly

Do not plug the table saw into the power source until all assembly has been completed! Failure to comply may cause serious injury!

Where to Begin

Each assembly section will start by listing the applicable model(s) for that assembly procedure. The starting point for your particular model, however, is as follows:

Models LSA, LSB: start with Leg Assembly below.	Figure 1
Models BTA, BTB, BTC: start with Installing the
Blade Guard and Splitter on page 12.

Leg Assembly

Models LSA, LSB

Follow these Leg Assembly instructions if you plan to use your saw as a floor model. If this saw is to be used for bench top applications, skip this section and proceed to the Extension Table section.

Tools required – 10mm socket and wrench Referring to Figures 1 and 2:

Required hardware (for each leg): two M6x12 hex cap screws (C) and three M6 flange hex nuts (F).

1.With the saw upside down on the floor, remove the four rubber feet (A) from each corner of the base.

2.Take one leg (B) and position it so the outside tab (G), containing the mounting hole, is towards the bottom.

3.Mount one leg to a corner of the saw base so the hole in the outside tab (G) lines up with the screw (H) and the two holes on the leg's inside tab (J) rests on top of the base tabs (K) with the mounting holes lined up.

Note: The leg with the WARNING label must be mounted on the corner of the saw base that also has the WARNING label.

4.Insert two hex cap screws (C) through the mounting holes of the leg tab (J) and base tab

(K). Secure with flange hex nuts (F1). Hand- tighten only.

Figure 2

5.Secure the leg's outside tab (G) to the screw

(H)on the base with a flange hex nut (F2). Hand-tighten only.

Mount two more legs in the same manner described in steps 1–5. Don't mount the last leg until the shelf is installed as described in the next section.

10