Trigger
For setting whether to supply a 12 V output to devices such as an external screen equipped with a trigger function.
Setting |
| Description |
Off | No output. | |
On (Power) | Outputs control signals (12 V) from the trigger terminal when the power is turned | |
| on. | |
| 0 | After the power is turned off, output stops when the unit shifts to the Standby |
|
| mode after cooling is complete. |
| 0 | You can also output signals in the Standby mode by pressing the [OK] button. |
On (Anamo) | Outputs control signals when the “Anamorphic” setting is switched from “Off” to “A” | |
| or “B”. | |
For setting the duration before the power turns off automatically when the projector is not operated.
0Setting values: “1 Hour”, “2 Hours”, “3 Hours” and “4 Hours”
ECO Mode
For setting the “ECO Mode”, which reduces power consumption when the projector is in the standby state.
Setting | Description |
On | Minimizes power consumption in the Standby mode. |
| 0 If there is no signal transmission and operation for 30 minutes while an image |
| is projected, the power is turned off automatically. |
Off | Set to “Off” if |
| is used in the Standby mode. |
Specify the settings below during external control such as from a PC or smartphone.
Setting |
| Description |
DHCP Client | On | Obtains the IP address automatically from the DHCP server inside the connected |
|
| network. |
| Off | For configuring the network settings manually. |
IP Address |
| For configuring the IP address. |
Subnet Mask |
| For configuring the subnet mask. |
Default Gateway |
| For configuring the default gateway. |
MAC Address |
| Displays the MAC address of the unit. |
Set |
| Applies the network settings. |
Adjust/Set
59