Resetting the Lamp Time

Reset the lamp time when you have replaced the lamp. It provides an estimated timing for lamp replacement

Resetting the lamp time from the menu screen

1Press the [MENU] button to display the menu

2Select “Function”"“Lamp Reset” from the menu

 

 

Function

Trigger

 

Off

Off Timer

 

Off

ECO Mode

 

Off

Network

 

A

Remote Code

Lamp Reset

 

 

Exit

Select

Operate Back

MENU

BACK

.

3On the “Reset Lamp Time?” screen, select “Yes” and press the [OK] button

0The lamp time is reset to zero.

Reset Lamp Time?

Resetting the lamp time using the remote control

1Insertoutlet the power plug into the power

Make sure that you operate the

2remote control in the Standby mode (the power plug is inserted into the

outlet, but the power is not turned on)

0Press in the order as shown.

0Make sure that you press a button within two seconds after the last button is pressed. Press the last button for at least two seconds.

Press for 2 seconds or longer

.

0The “LAMP” indicator and “STANDBY/ON” indicator blink alternately for three seconds. After that, the unit switches to the Standby mode.

YesNo

.

MEMO

0Reset the lamp time only when you have replaced the lamp.

If the lamp time is reset while a lamp is in use, you may lose track of the timing for replacing the lamp. Doing so may result in using the lamp beyond the estimated limit, thereby causing lamp blowout.

Maintenance

Maintaining the Cabinet and Remote Control

0Gently wipe off dirt on the cabinet with a soft cloth.

0If it is extremely dirty, wet a cloth in water, wring dry and use it to wipe off the dirt, followed by wiping again with a dry cloth.

0Pay attention to the following as the cabinet may deteriorate in condition or the paint may come off.

0Do not wipe with thinner or benzine

0Do not allow prolonged contact with rubber or plastic products

0Do not spray volatile chemicals such as insecticide

63