You can tell the details of a warning from the (repeated) displays of the “WARNING” and “LAMP” indicators. The “STANDBY/ON” indicator, which shows the operating mode of the unit, is displayed simultaneously as described above.
The Warning mode is activated once the message is displayed. Projection is interrupted, and the cooling fan is turned on for about 100 seconds.
The power cannot be turned on again while cooling is in progress. Check the following after cooling is complete.
Indicator Status (Solid/Blinking) | Blinking | Description |
| Check and Countermeasure | |||||||
Frequency |
| ||||||||||
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| x1 | Abnormality in the power supply | 0 | Check that nothing is blocking |
STANDBY/ON | LAMP | W | ARNING | x2 | Cooling fan stopped abnormally |
| the air inlets. | ||||
|
|
|
|
|
|
|
| 0 | Check that the external | ||
|
|
|
|
|
|
|
| x3 | Internal temperature is abnormally | ||
|
|
|
|
|
|
|
|
| temperature is normal. | ||
Mode | (*) |
|
| (Red) |
| high |
| ||||
|
|
| Countermeasure: Leave the unit | ||||||||
Display |
|
|
|
|
|
|
| x4 | External temperature is too high | ||
|
|
|
|
|
|
| unoperated until it cools down. | ||||
. |
|
|
|
|
|
|
| x5 | Abnormal circuit operation | After that, turn on the power again. | |
|
|
|
|
|
|
|
| ||||
STANDBY/ON |
| LAMP |
| W | ARNING | x1 | Abnormal circuit operation |
|
| ||
|
| x2 |
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
| |
Mode | (Orange) |
| (Red) | x3 |
|
|
| ||||
| x4 | Abnormal operation of the |
| Check that nothing is blocking | |||||||
Display |
|
| Blinking | 0 | |||||||
. | Simultaneously |
| automatic lens cover |
| the auto lens cover. | ||||||
|
|
|
|
|
|
|
|
| Countermeasure: Turn on the | ||
|
|
|
|
|
|
|
|
|
| power again. | |
|
|
|
|
|
|
|
| x1 | Lamp does not light up and unit is | 0 | Check that the lamp unit and |
STANDBY/ON | LAMPP |
| W | ARNING |
| unable to project |
| lamp cover are correctly | |||
|
|
|
|
|
|
|
| x2 | Lamp goes out during projection |
| installed. |
|
|
|
|
|
|
|
| Countermeasure: Turn on the | |||
Mode | (Orange) |
| (Red) | x3 | When the lamp cover is removed | ||||||
| power again. |
.
Display
If the Warning mode is activated again, wait for the cooling fan to stop, followed by pulling out the power plug from the outlet.
Request for repair at your authorized dealer or a nearby service center.
(*) If the scheduled time for lamp replacement is exceeded, the indicator may light up.
Others
79