Masterpage:Right+
EN 61
Filename [DR-MH30UJ_09Editing.fm]
EDITING
Page 61 Monday, 12 July 2004 14:25
You can use a camcorder as the source player and your unit as the
recording deck.
1Make connections.
AIf the camcorder has no S-VIDEO output connector:
connect the camcorders AUDIO/VIDEO OUT connectors to the
units AUDIO/VIDEO input connectors on the front panel.
When using a monaural camcorder, connect its AUDIO OUT
connector to the AUDIO L input connector on your unit.
BIf the camcorder has an S-VIDEO output connector:
connect the camcorders AUDIO OUT and S-VIDEO OUT
connectors to the units AUDIO and S-VIDEO input connectors on
the front panel.
2Press HDD or DVD repeatedly to select the recording deck.
3Press CH +/ to select F-1.
Set FRONT AUX F-1 to VIDEO for the VIDEO input connector, or
S-VIDEO for the S-VIDEO input connector, depending on the
connector being used. (pg. 68)
4Press REC MODE repeatedly to set the recording mode.
5Start playback on the camcorder slightly before the actual point
from where you wish to start dubbing.
6Press 7 on the unit to start recording. Or press and hold 7 and
press 4 on the remote control. The dubbing starts.
7Press 8 on the unit, then stop playback on the camcorder.
NOTES:
All necessary cables can be obtained from your dealer.
Refer to the camcorders instruction manual for operating procedure.
The quality of dubbed picture becomes poorer than that of the
original.
Edit From A Camcorder
AIf the camcorder has no S-VIDEO output connector:
Recorder
Player
AUDIO/VIDEO input
Audio/video cable
(not provided)
AUDIO/VIDEO OUT
BIf the camcorder has an S-VIDEO output connector:
S-VIDEO input
AUDIO input
S-video cable
(not provided)
AUDIO OUT
Audio cable
(not provided)
S-VIDEO OUT
Recorder
Player
Slide the TV/CABLE/DBS/DVD switch to DVD.
DR-MH30UJ_00.book Page 61 Monday, July 12, 2004 3:17 PM