Filename [DR-MH30UJ_09Editing.fm]
Masterpage:Left0
66 EN
Page 66 Monday, 12 July 2004 14:25

SYSTEM CONNECTIONS

These instructions enable you to connect your unit to a Dolby
Digital Decoder or an amplifier with built-in DTS.
1Connect the unit and a Dolby Digital Decoder or an amplifier
with built-in DTS using either an optional optical cable or an
optional coaxial cable.
NOTES:
For Dolby Digital sound, set DIGITAL AUDIO OUT to DOLBY
DIGITAL/PCM. (pg.67)
For DTS sound, set DIGITAL AUDIO OUT to STREAM/PCM.
(pg. 67)
CAUTIONS:
This unit has a dynamic range of more than 110 dB with regards to its
Hi-Fi audio capability. It is recommended that you check the
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to the
speakers may damage them.
Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do not
place the speakers adjacent to the TV set as this can adversely affect
the playback picture.
Connecting To A Dolby Digital Decoder Or An Amplifier With Built-in DTS
1
L-2
Note for connection:
Remove the protection cap from the optical
cable.
Optical cable
(not provided)
Dolby Digital Decoder or
amplifier with built-in DTS
To DIGITAL AUDIO input
Coaxial cable
(not provided)
DIGITAL OUT (COAXIAL)
DIGITAL OUT (OPTICAL)
DR-MH30UJ_00.book Page 66 Monday, July 12, 2004 3:17 PM