JVC DT-V1710CG, DT-V1910CG manual MAKE/TRIGGER terminal, RS-485 OUT terminal, On  OFF

CONTROLS AND FEATURES (cont'd)

19 Power lamp

Unlit : The main power is OFF.

Orange : The main power is ON, but the monitor’s power is OFF (in stand-by mode).

Green : The main power is ON, and the monitor’s power is ON (in normal operation mode).

20POWER switch

Press the power switch to turn the monitor’s power ON or OFF when the main power is ON.

NOTE:

When RUSH DELAY TIME is set to SLOW in the set-up menu, it takes approx. 3.2 seconds for the power to actually turn ON after the power switch is pressed.

REAR/SIDE VIEW

<Rear Panel> <Side Panel>

						REMOTE
						MAKE/TRIGGER	21
G / Y		SWITCHED			IN
B/P	/B-Y	OUT
IN	OUT					RS-485
		HD SDI 1
IN	OUT
R/P	/B-Y	IN			OUT
IN	OUT
HD/C							22
		IN
IN	OUT
VD		HD SDI 2		SLOT1	SLOT2
		AUDIO
IN	OUT
AUDIO		IN	OUT
IN	OUT			SLOT3

23

MAIN POWER

24

25

(Rear view of DT-V1910CG shown)

21 REMOTE (external control) terminals

Terminals for controlling the monitor from an external unit.

MAKE/TRIGGER terminal:

Enables the monitor to be controlled by closing the circuit (point of contact) connected to the terminal.

RS-485 IN terminal:

Enables the monitor to be controlled from a personal computer via a serial cable.

RS-485 OUT terminal:

Enables a cascade control connection. Multiple monitors can be controlled by the device connected to the IN terminal.

22 Input card slots (SLOT 1 – SLOT 3)

Optional input cards can be installed in these slots. Input cards are not provided when you purchase the monitor.

NOTE:

It is not possible to input video or audio signals to the monitor when no input cards are installed.

23Main power switch

Press the switch to turn the main power ON or OFF. When the main power is ON, the power lamp on the front panel lights in yellow and the monitor enters the stand-by mode.

• I : ON  : OFF

(Side view of DT-V1910CG shown)

24AC inlet

Power input connector. Connect the provided AC power cord to an AC outlet (120 V/230 V AC, 50 Hz/ 60 Hz).

*Attach the provided Power Cord Holder to prevent accidental disconnection of the AC power cord.

Refer to page 12 for details.

25Built-in speaker (monaural)

Outputs the selected INPUT audio signal.

6