JVC DT-V1910CG, DT-V1710CG manual Secure the wide mask with the screws fix

PREPARATION

INSTALLING THE INPUT

CARD

Optional input cards are necessary to use the functions of this monitor. Before mounting the monitor or connecting other equipment to the monitor, be sure to install the input cards.

1.Turn off the Multi-Format Monitor’s main power and unplug the power cable from the AC outlet.

2.Unscrew the screws and remove the slot cover from the slot (on the rear side of the monitor) in which you are going to install the card.

REMOTE

	MAKE/TRIGGER
	RS-485
	IN
	OUT
SLOT1	SLOT2
SLOT3	Slot cover

Rear side of the DT-V1910CG

Multi-Format Monitor

3.Insert the Input Card’s board (green- coloured) into the slot, fitting the board into the guide rails on the top and bottom of the slot.

Fit the board to
the guide rails.
	REMOTE
	MAKE/TRIGGER
Knob	RS-485
	IN
	OUT
SLOT1	SLOT2
SLOT3

ATTACHING THE WIDE

MASK

A wide mask is provided with the monitor. This changes the viewable screen area to the 16:9 aspect ratio.

•The wide mask cannot be attached to the monitor after the monitor is mounted in a rack. Mount the wide mask before installing the monitor in a rack.

1.Prepare the provided wide mask and 4 screws (for attaching).

2.Attach the wide mask to the monitor.

ENGLISH

3. Secure the wide mask with the screws (fix

2 screws each to both right and left side).

Knob

Guide rails

Input card (the illustration shown is of the IF-C01PNG)

4.Push the Input Card in so that its front panel touches the monitor’s rear panel.

5.Secure the Input Card by replacing the

screws removed in Procedure 2.

●When detaching the wide mask, follow this procedure in reverse.

Caution:

Use only the provided screws.

SLOT3SLOT1

NOTES:

REMOTE

MAKE/TRIGGER

RS-485

IN

OUT

SLOT2

•Do not touch the terminal connected to the monitor or board pattern.

•Do not remove slot covers from the monitor’s slots if they are not in use.

11