JVC DT-V1910CG, DT-V1710CG manual COMPONENT/RGB Input Card IF-C01COMG, Video Input Card IF-C01PNG

CONTROLS AND FEATURES

(INPUT CARD: OPTIONAL)

⬛COMPONENT/RGB INPUT CARD (IF-C01COMG)

G / Y
IN	OUT
B/PB/B-Y
		1
IN	OUT
R/PR/B-Y
IN	OUT	4
HD/CS
IN	OUT	2
VD

INOUT

AUDIO

3

IN OUT

⬛Compatible signal formats: 480/60i, 576/50i, 576/50p, 480/60p, 720/60p, 1035/60i, 1080/50i, 1080/60i, 1080/24psF

1 Component/RGB signal input/output terminals

Input (IN) and output (OUT) terminals for component (colour difference) or RGB signals.

Select component signal: INPUT SELECT A (SLOT1)/C (SLOT2)/E (SLOT3)

Select RGB signal : INPUT SELECT B (SLOT1)/D (SLOT2)/F (SLOT3) * The IN and OUT terminals are bridge-connected (auto termination).

2 Synchronized signal input/output terminals

Input (IN) and output (OUT) terminals for the vertical, horizontal or complex synchronized signals.

•To use these terminals, set “SYNC SELECT” to “EXT”.

Refer to “SYNC SELECT” on page 19 for more information.

3 Audio input/output terminals

Input (IN) and output (OUT) terminals for the analogue audio signals.

• The IN and OUT terminals are bridge-connected.

4 Connection terminal

Attach to the connection terminal of your Multi-Format Monitor.

⬛VIDEO INPUT CARD (IF-C01PNG)

VIDEO1

IN	OUT	1
	VIDEO2
IN	OUT
	Y/C IN	2

EXT.SYNC

3

IN OUT

AUDIO1

IN OUT 4

AUDIO2

5

⬛Compatible signal formats:

NTSC (3.58 MHz), PAL (4.43 MHz), black-and-white (50 Hz/60 Hz)

1 Composite signal input/output terminals (VIDEO 1, VIDEO 2)

Input (IN) and output (OUT) terminals for the composite video signals of the NTSC, PAL, and black/white (50 Hz/60 Hz).

NTSC and PAL are switched in the “COLOR SYSTEM”. Refer to “COLOR SYSTEM” on page 19.

Select VIDEO 1: press INPUT SELECT A (SLOT1)/C (SLOT2)/E (SLOT3) buttons.

Select VIDEO 2: press INPUT SELECT B (SLOT1)/D (SLOT2)/F (SLOT3) buttons.

* The IN and OUT terminals are bridge-connected (auto termination).

2 S-video signal input terminal (only for VIDEO 2)

Input terminal for the S-video signal.

•When an S-video signal is input to this terminal and a video signal is input to VIDEO 2, the S-video signal has priority over the video signal.

3Synchronized signal input/output terminals (for both VIDEO 1 and VIDEO 2)

Input (IN) and output (OUT) terminals for the complex synchronized signals.

To use these terminals, set “SYNC SELECT” to “EXT”. Refer to “SYNC SELECT” on page 19 for more information.

NOTES:

•When an external synchronized signal is input, external synchronization is prioritized for both VIDEO 1 and VIDEO 2.

•External synchronization does not function when a video signal (except black burst signal) is included in the complex synchronized signal.

4Audio signal input/output terminals (for both VIDEO 1 and VIDEO 2)

Input (IN) and output (OUT) terminals for analogue audio signals corresponding to VIDEO 1 and VIDEO 2.

• The IN and OUT terminals are bridge-connected.

5 Connection terminal

Attach to the connection terminal of your Multi-Format Monitor.

7