JVC GV-PT2 48

48 EN

REQUIRED HARDWARE

qBi-Directional 25-pin printer interface

q486DX2 or higher CPU

OPERATING ENVIRONMENT

qPersonal computer with MicrosoftT* WindowsT* Operating System Version 3.1

(also verified to run with MicrosoftT WindowsT 95)

*MicrosoftT and WindowsT are trademarks of the Microsoft Corporation registered in the

United States and other countries.

q16 MB RAM or more

qAt least 8 MB available hard disk space

qColour display capable of handling at least 640 x 480 dots and 256 colours

(Recommended: true colour 24-bit)

qWindowsT-compatible mouse connected to PC

q3.5” 1.44MB floppy disk drive

qPC which allows setting of Parallel Port to “Bi-Directional” or “Enhanced Parallel Port” mode.

qBIOS setting (with EPP or Bi-Directional setting) (see below)

BIOS SETTING

The GV-PT2 Driver & Capture Utility Software is designed to use a two-way communications

interface as a prerequisite in the environment of WindowsT. It runs when the parallel-port mode

is set to EPP or Bi-Directional (represented as PS/2 Exchange mode or Extension mode in some

PCs). On some PCs, it may not run properly even though the Parallel Port mode is set to EPP.

The initial setting of some PCs may not be EPP or Bi-Directional. In this case, set the mode to

EPP or Bi-Directional using the PC’s set-up utility. Refer to your computer’s user manual for

details.

Some PCs capable of two-way communications may not provide any setup indication for EPP or

Bi-Directional. In this case, consult the manufacturer of your computer.

INTRODUCTION

Contents

Main EN 1 SAFETY PRECAUTIONS If in doubt consult a competent electrician. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. NOTE: IMPORTANT (for U. K. owners) 2 Some Do's And Don'ts On The Safe Use Of Equipment EN 3 CAUTIONS 4 MAJOR FEATURES A Variety of Special Effects Printing Options EN 5 LAYOUT PRINT (page 36) Horizontal layout (page 18) Name Sticker Video cassette label (page 34) Vertical layout (page 32) Calendar 6 CONTENTS Page 8 CONTROLS, INDICATORS AND CONNECTORS !@ # $%^ 1 2 345 7 8 9 0 6 &* () q 10 CONTROLS, INDICATORS AND CONNECTORS (cont.) PREPARATION OF THE REMOTE CONTROL (RC) UNIT 12 CONNECTIONS Connection using S-video cable is recommended to ensure a clearer print. EN 13 TO CONNECT TO AN IMAGE SOURCE WITH REGULAR VIDEO OUTPUT CONNECTORS 14 OPEN CASSETTE DOOR TAKE UP SLACK INSTALL INK CASSETTE CLOSE CASSETTE DOOR About Blank Paper Sheet Sets (optional) SET CONTENTS USES 16 Opening the paper tray LOADING THE PAPER TRAY Inserting blank paper sheets in the paper tray Loading/unloading the paper tray 1 2 6 3 5 18 BASIC PRINTING SELECT LAYOUT AND NO. OF SCENES EN 19 20 DIFFERENT TYPES OF PRINTING Setting (with remote control unit) Print menu display 23,4 Select Layout Z 22 Multi-Print (Same Scene) SELECT SAME ON CONTENT Z Page 24 Multi-Print (Different Scenes) SELECT DIFFERENT ON CONTENT Z Page 26 Multi-Print (Different Scenes Sticker Type Print) 5, SELECT EDITING INDEX EN 27 PRESS MEMORY WHEN THE DESIRED IMAGE APPEARS REPEAT STEP 5 FOR EACH IMAGE YOU ARE GOING TO PRINT (UP TO 16) AND STORE THEM 28 Inset Print 1,5 3,7 4,10 11 2,6,8 Store the main scene Store the sub scene SELECT DIFFERENT ON CONTENT SELECT THE POSITION WHERE THE SUB SCENE IS STORED WITH CUR- SOR BUTTONS / AND PRESS SOURCE BUTTON WHEN THE IMAGE YOU WANT TO SELECT AS A SUB SCENE IS REACHED, PRESS MEMORY 30 Strobe Print SELECT STROBE<HIGH> OR STROBE<LOW> ON CONTENT Z EN 31 32 Vertical Layout Print / An image can be printed on the upper half of a print sheet. See page 17. EN 33 34 Video Cassette Label Print SELECT VIDEO CASSETTE ON LAY- OUT EN 35 36 Name Sticker Print SELECT NAME STICKER ON LAYOUT EN 37 38 See page 17. / ,7 4, EN 39 SET YEAR/MONTH OF CALENDAR PRESS OK BUTTON 40 Editing Index CONNECT IMAGE SOURCE (CAMCORDER OR VCR) TO PRINTER (PAGE 12, 13) SET EDIT-IN OR EDIT-OUT POINT OF THE SCENE TO BE STORED EN 41 CHOOSE EDITING INDEX PRESS THE CAMCORDERS EDIT START BUTTON OR THE VCRS START BUTTON BACD FEGH JIKL NMOP 42 EN 43 REWIND THE TAPE IN THE CAMCORDER TO THE SCENE YOU WANT TO PRINT, THEN PAUSE THE TAPE SELECT SNAP SHOT PRINTING PRESS THE CAMCORDERS SNAP SHOT BUTTON 44 Title Impose Print 4,5,7 STORE THE DESIRED IMAGE IN MEMORY RECORD TITLE OR DRAWING WITH YOUR CAMCORDER EN 45 WHEN THE TITLE OR DRAWING TO BE PRINTED HAS BEEN CHOSEN, 7 2 CHOOSE NEGATIVE/POSITIVE OF THE TITLE 46 Using The Attached Collection Of Superimpose Patterns Shooting a pattern NOTES: Page 48 INTRODUCTION REQUIRED HARDWARE OPERATING ENVIRONMENT BIOS SETTING SOFTWARE FEATURES DRIVER WINDOW CAPTURE UTILITY WINDOW FOR IMAGE CAPTURING THINGS YOULL NEED IN ADDITION THE PROVIDED ACCESSORIES 50 PERIPHERAL UNIT CONNECTIONS Machine with S-Video or Video output connector compatible with PAL signals EN 51 52 INSTALLING THE SOFTWARE 5. INSTALLING IN A WINDOWS-COMPATIBLE PC INSTALLATION EN 53 Run OK Cancel Browse Read to the end of the text (press the scroll button to scroll the text.) 54 OPEN & CLOSE (Basic Operation Procedure) GETTING STARTED EN 55 CLOSING THE PROGRAM 56 CONTROLS AND OPERATIONS MENUBAR File(F) EN 57 58 CONTROLS AND OPERATIONS Tile Cascade Arrange Icons EN 59 1,9 PRINTING PROCEDURE PRINTING AN IMAGE FROM YOUR PC Preparation: VIDEO PRINTER OPERATION 60 PRINTING PROCEDURE PC OPERATION Windows 9 EN 61 62 Page 64 VIDEO PRINTER MODE EN 65 66 PC PRINTER MODE EN 67 PC PRINTER MODE Message Page 68 OTHER PROBLEMS: Check to see ifIf EN 69 WHEN PAPER JAMS If no paper is jammed in the output tray If no paper is jammed in the slot of the paper tray 70 SPECIFICATIONS INDEX C E F H