PREPARATION OF THE REMOTE CONTROL (RC) UNIT EN 11
How to install the batteries
Place two R6 batteries in the
How to aim the remote control unit
compartment. Align the batteries as shown.
Remote control signal receiver
Approx.
30°
Within 5 m
Operating distance depends on the ambient brightness and the angle at which the RC unit is aimed at the receiver.
Notes on the batteries
●Remove the batteries from the RC unit when not using it for a long period.
●If the RC unit does not work properly, remove the batteries from the unit and let it stand for a while, then replace the batteries and try using it again.
When to replace the batteries:
●When the remote control’s operating distance starts to decrease, it means that the battery level is dropping. In this case, replace the batteries with new ones.
When replacing the batteries
●Use two R6 batteries.
●Replace both batteries at the same time. Do not mix new batteries with used batteries.
●Insert the batteries in accordance with the + and – indications.
●Be sure to read the precautions on the battery label.
