JVC GY- HD111 HD CAMERA RECORDER AC Operation, „ Charging the Built-in Battery, „ How to charge

PREPARATIONS

AC Operation

		POWER lamp
		To plug outlet
DC INPUT		DC OUT
connector	AC adapter	connector
	Ferrite core

DC cable

The GY-HD110 is operable with AC power supply or battery pack.

Use the supplied AC adapter as the AC power supply.

1.After making sure that the power switches of the GY- HD110 and of the AC adapter are set to OFF, connect the DC cable from the AC adapter to the DC INPUT connec- tor of the GY-HD110 as shown in the illustration.

2.Press the POWER switch of the GY-HD110 to ON. Power is supplied to the VTR section and the camera.

CAUTION

•When using the DC cable make sure to connect the end of the cable with the ferrite core to the AC adapter.

•Do not remove or connect the DC cable while recording is being performed.

•Do not use any power source with large fluctuations in the power source voltage, power sources generating noise, such as ripples or power sources with lower voltage.

Attach the supplied core filter (gray) as shown in the diagram on the right to reduce unwanted electromagnetic emission.

zAttach the core filter as shown in the diagram on the left to this unit as near as possible.

Core filter (gray)

„ Charging the Built-in Battery

The built-in, rechargeable backup battery retains the date and time and the time code data.

The built-in battery is constantly being charge whenever the GY-HD110 is connected to a power supply, but it gradually discharges while the GY-HD110 is disconnected from a power supply. The battery will be fully discharged when the GY- HD110 is not used for about three months, in which case the set date and time and time code data are reset.

In this case, recharge the built-in battery and then set the date and time and time code data again.

However, it is possible to use the GY-HD110 even if the built- in battery is discharged but the date and time and time code data cannot be recorded.

„How to charge

1.Connect the provided AC adapter to the GY-HD110 and an AC outlet or mount a charged battery on the GY- HD110.

2.Set the POWER switch on the GY-HD110 to “ON” or “OFF” (charging takes places with the POWER switch set to either of the positions.)

3.Leave the equipment in this condition for about 4 hours.

•The built-in battery will remain charged for about 3 months after being charged for about 4 hours.

32