JVC HM-DR10000EU Basic Playback, Load a Cassette, Point, Start Playback, Stop Playback

PLAYBACKEN15

Basic Playback

Turn on the TV and select the AV mode.

REW FF

EJECT	STOP	PLAY
	1	3
	2

The easiest, most basic operation possible with your video recorder is tape playback. Already-recorded signals on a video tape are read by your video recorder and displayed on your TV just like a TV programme.

●This recorder can play back tapes that have been recorded in D-VHS (MTP), S-VHS and VHS formats.

●When playing back a tape, this recorder automatically identifies the recording format (D-VHS, S-VHS, or VHS).

1		LOAD A CASSETTE
	Make sure the window side is up, the rear label side is
		facing you and the arrow on the front of the cassette is
		pointed toward the recorder. Do not apply too much
		pressure when inserting.
		● The recorder power comes on automatically and the
		counter is reset to 0:00:00.
		● If the record safety tab has been removed, playback
		begins automatically.
		FIND PROGRAMME START
2		POINT
	If the tape is advanced past the start point, press REW.
		To go forward, press FF.
3		START PLAYBACK
	Press PLAY. "BEST" appears blinking in the recorder's
		display panel during automatic tracking (only cassettes
		recorded in the S-VHS or VHS mode ☞ pg. 28).
4		STOP PLAYBACK
	Press STOP. Then press EJECT to remove the cassette.

Tape Position Indicator

P

L

AY

FF

REW

	P
	O
T
S

The tape position indicator appears on screen when, from the Stop mode, you press FF, REW or perform an Index Search. The position of "5" in relation to "0"

(beginning) or "+" (end) 0 + shows you where you are

on the tape.

"O.S.D." (☞ pg. 11) must

be set to "ON", or the Beginning indicator will not appear.

3

+ +

1:23:45 REMAIN 2:35

End

NOTE:

Depending on the type of tape used, there may be times when the indication is not correct.