JVC HR-J631T manual Recording, Press and hold REC, Quality of the tape Use, then recording

PAUSE

6

q

REC

PLAY

1 2 3

4 5 6

7 8 9

0

PAUSE

REC

23

Recording

Perform steps 1 – 3 on page 13 ("Simple Recording") before continuing.

	START RECORDING
	Press and hold REC and			DURING B.E.S.T.
	press PLAY on the remote
1 control, or press REC on
	the VCR's front panel.
	● The VCR takes about 7
	seconds to assess the	START			END
	quality of the tape in
		+	+		+
	use, then recording
		B.E.S.T.PICTURE SYSTEM
	begins with the picture
	level optimized.
	NOTES:		B.E.S.T. COMPLETE

●B.E.S.T. occurs immedi- ately prior to both the first SP and the first EP recording after inserting

the cassette. It does not	START		END
take place during
	+	+	+
recording.
	B.E.S.T.PICTURE SYSTEM

●In the case of timer

recording, B.E.S.T. takes place for both SP and EP before the first timer recording after inserting the cassette (regardless of the tape speed selected for that recording).

●Once the cassette is ejected, the B.E.S.T. data is canceled. The next time the cassette is used for recording, B.E.S.T. is re-performed.

●While B.E.S.T. is operative, the PAUSE button will not function.

●SUPERIMPOSE must be set to "ON" or the B.E.S.T. Picture System screen will not appear (☞ pg. 18).

ATTENTION:

■As B.E.S.T. takes place before recording actually starts, there is a delay of about 7 seconds after REC and PLAY on the remote, or REC on the VCR's front panel, are pressed. To make sure you record the desired scene or program completely, first perform the following steps:

1)Press and hold PAUSE, and press REC to engage the RECORD PAUSE mode.

●The VCR then automatically checks the condition of the tape and, after about 7 seconds, re-enters RECORD PAUSE.

2)Press PLAY to start recording.

■If you want to bypass B.E.S.T. and start recording right away, set "RECORDING" to "OFF" in step 4 of the Preparation procedure (☞ pg. 22).