JVC HR-J631T manual Access Function Set Screen, Auto SP/EP Timer, Access Auto Sp/Ep Timer Screen

OK

CH

MENU

6

q

33

Auto SP/EP Timer

If, when recording in SP mode, there is not enough tape to record the entire program, the VCR automatically switches to EP mode to allow complete recording. This feature is especially handy when recording a program of more than 2 hours in length.

For Example . . .

Recording a program of 140 minutes in length onto a 120- minute tape

Approximately 110 minutes	Approximately 30 minutes
SP mode	EP mode

Total 140 minutes

Make sure you select “ON” at the Auto SP/EP Timer screen before performing timer programming.

1 2 3

4	5	6
7	8	9
	0	OK

MENU

CH

1

2

3

ACCESS MAIN MENU SCREEN

Press MENU as many times as necessary.

ACCESS FUNCTION SET SCREEN

Place the arrow next to "FUNCTION SET" by pressing CH5°, then press OK.

ACCESS AUTO SP/EP TIMER SCREEN

Place the arrow next to “AUTO SP/EP TIMER” by pressing CH5°, then press OK.

4

SELECT MODE

Place the arrow next to your choice (“ON” or “OFF”) by press CH5°.

AUTO SP/EP TIMER

=ON

OFF

PRESS (5,°) TO SELECT

PRESS (MENU) TO END

NOTES:

●If you have programmed the VCR to timer-record 2 or more programs, the second program and those thereafter may not fit on the tape if you set the Auto SP/EP Timer mode to "ON". In this case, make sure the mode is not engaged, then set the tape speed manually during timer programming.

●There may be some noise at the point on the tape where the VCR switches from SP to EP mode.

●The Auto SP/EP Timer feature is not available during ITR (Instant Timer Recording), and the feature will not work properly with any tapes other than the following: T-30, T-60, T-90, and T-120.

5

RETURN TO NORMAL SCREEN

Press MENU as many times as necessary.