JVC HR-S7500U Start Search, Access Distant Code, Activate High-Speed Search, Index Search, EN25

Index Search

Index codes are placed on the tape at the start of each recording. You can find and automatically play back from the start of any recording using the Index Search function.

1	START SEARCH
	While the tape is stopped, press TIME SCAN ª or
	£ (@or #).
2	ACCESS DISTANT CODE
	To access a recording 2–9 index codes away, press
	TIME SCAN ªor £ (@or #) repeatedly until the
	correct number is displayed on screen (only if "SUPER-
	IMPOSE" is set to "ON" (☞ pg. 28). Playback begins
	automatically when the desired recording is located.
	● If necessary press REW or FF when play starts to
	search visually to find the very beginning of the
	desired program.

NOTE:

An index code is not placed on the tape when recording is paused and then resumed.

High-Speed Search

ACTIVATE HIGH-SPEED

SEARCH

1 During playback or still, press FF for forward high- speed search, or REW for reverse high-speed search.

●The search speed is 7 times normal playback speed with SP recordings, and 21 times normal with EP recordings.

●TimeScan will be automatically engaged during high- speed search with an SP-recorded tape.

●If the tape speed changes from SP to EP during high- speed search the TimeScan mode will change to EP search mode.

●During high-speed search with an EP-recorded tape, pressing TIME SCAN for the opposite direction or turning the TIME SCAN SHUTTLE ring to the

opposite direction changes it to 7x-speed TimeScan search. (☞ pg. 35)

To resume normal playback, press PLAY.

NOTE:

For short searches, during playback or still, press and hold FF or REW for over 2 seconds. When released, normal playback resumes.

EN25

Manual Tracking

Once playback begins, the VCR’s automatic tracking function is engaged. If tracking noise appears in the picture, you can override this and make the adjustment manually.

ENGAGE MANUAL

TRACKING MODE

1 During playback, press the CH5 and ° buttons on the

VCR's front panel simultaneously to cancel the automatic tracking mode and enable manual tracking adjust.

ADJUST MANUAL

TRACKING

2 Press CH 5(+) or ° (–) on the VCR's front panel or remote. Press briefly for fine adjust, or press and hold for coarse adjust. Watch the screen and continue adjusting until optimum picture and sound quality are achieved.

RE-ENGAGE AUTOMATIC

TRACKING

3 Press the CH5 and ° buttons on the VCR's front panel simultaneously.

●When automatic tracking is re-engaged, Video Calibration is automatically activated.

NOTES:

●To obtain a noiseless still picture it may be necessary to adjust tracking in slow playback and then engage Pause.

●Manual tracking is possible during hands-free slow-motion. During hands-free slow-motion playback, simply press CH 5 (+) or ° (–) on the VCR's front panel or remote to adjust tracking.