JVC LPT0319-001A, HR-S8700EK setup guide Satellite Receiver Control Setting

12SATELLITERECEIVERCONTROL

Satellite

Receiver

Control Setting

The following procedure is required if you receive satellite channels through a satellite receiver. Around 20 seconds before VIDEO Plus+ timer recording (☞ pg. 18) or Express timer programming (☞ pg. 20) starts, the recorder sets its input mode to "L-2" and automatically switches the satellite receiver’s channels using the provided Satellite Controller.

Satellite receiver

Your recorder	Satellite Controller
	(suggested locations)
Transmitter	Satellite Controller
Satellite receiver

21-pin SCART cable

SAT CONTROL

AV2 (L-2) IN/DECODER

Back of Recorder

Installing Satellite Controller

	SITUATE SATELLITE
1	CONTROLLER
	Place the Satellite Controller so that the path between
	its transmitter and the satellite receiver’s remote sensor
	is unobstructed.
	ATTACH SATELLITE
2	CONTROLLER
	Fix securely using the adhesive strip attached on the
	back of the Satellite Controller.
3	MAKE CONNECTIONS
	Be sure to connect the recorder’s AV2 (L-2) IN/DECODER
	connector to the satellite receiver’s 21-pin SCART connector.
	NOTE:
	When connecting your satellite receiver, refer to its
	instruction manual.
	CONNECT SATELLITE CON-
4	TROLLER TO RECORDER
	Connect the Satellite Controller to the SAT CONTROL
	connector on the rear panel.

Setting satellite receiver's brand and channel

After installation, set the satellite receiver’s brand and channel correctly; otherwise, the Satellite Controller cannot work correctly.

Turn on the TV and select the VIDEO channel (or AV mode).

	TURN ON SATELLITE
1	RECEIVER
	Turn on the satellite receiver’s power.
	ACCESS MAIN MENU
2	SCREEN ON RECORDER
	Press MENU.
	ACCESS INITIAL SET
3	SCREEN
	Press %Þ to move the	MAIN MENU
	highlight bar (pointer) to	MODE SET
	“INITIAL SET”, then press
		AUTO CH SET
	OK or #.	MANUAL CH SET
		OUTPUT/INPUT SET
		INITIAL SET
		REC LEVEL CTLT
		VIDEO NAVIGATION
		[5°] =
		[MENU] : EXIT