JVC LPT0319-001A Load a Cassette, Find Programme Start Point, Start Playback, Stop Playback

14

BASICOPERATIONS

Playback

Turn on the TV and select the VIDEO channel (or AV mode).

	3	2
		SHUTTLE
	PLAY
	1
STOP/EJECT		PAUSE
		JOG
	–
4	PR+/

The easiest, most basic operation possible with your video recorder is tape playback. Already-recorded signals on a video tape are read by your video recorder and displayed on your TV just like a TV programme.

LOAD A CASSETTE

1 Make sure the window side is up, the rear label side is facing you and the arrow on the front of the cassette is pointing towards the recorder. Don’t apply too much pressure when inserting.

●The recorder power comes on automatically and the counter is reset to 0:00:00.

●While "– – – –" is blinking on the front display panel, the tape will run for a few seconds to search for the tape number.

●If the record safety tab has been removed, playback begins automatically.

FIND PROGRAMME START POINT

2 If the tape is advanced past the start point, press REW or turn the SHUTTLE ring to the left. To go forward, press FF or turn the SHUTTLE ring to the right.

START PLAYBACK

1

2

– –:– –

1 2 3

4 5 6

7 8 9

0

TV/VCR

3

4

4

3 Press PLAY. "BEST" appears blinking in the recorder's display panel during automatic tracking (☞ pg. 38).

●Playback picture quality of LP/EP recordings will not be as high as SP recordings.

STOP PLAYBACK

4 Press STOP on the remote or STOP/EJECT on the recorder’s front panel. Then press STOP/EJECT to remove the cassette.

1	3
3 2	PR
LAY
2 REW	FF 2
4 STOP	PAUSE

Tape Position Indicator

Clean the video heads using a dry cleaning cassette — JVC TCL-2U — when:

●Rough, poor picture appears while a tape is played back.

●The picture is unclear or no picture appears.

●"USE CLEANING CASSETTE" appears on the screen (only with "O.S.D." set to "ON" (☞ pg. 55)).

INFORMATION

When using the AV connection (☞ pg. 6), initiating playback causes the VCR indicator to light and the TV to automatically enter AV mode. To return the TV to TV mode after playback is complete, press TV/VCR so that the VCR indicator turns off.

*Depending on the type of TV used, TV/VCR button does not always function as described above.

The tape position indicator appears on screen when, from the Stop mode, you press FF, REW or perform an Index Search. The position of “5” in relation to “0” (beginning) or “+” (end)

shows you where you are on 0 + the tape.

”O.S.D.” (☞ pg. 55) must

be set to “ON”, or the

indicator will not appear. Beginning

3

+ +

1:23:45 REMAIN 2:35

End

Usable cassettes

● Compact VHS camcorder recordings can be played on this video recorder. Simply

place the recorded cassette into a VHS Cassette Adapter and it

can be used just like any full-sized VHS cassette.

● This video recorder can record on regular VHS and

Super VHS cassettes. While only VHS signals can be

recorded on regular VHS cassettes*, both VHS and

Super VHS signals can be recorded and played back

NOTE:

Depending on the type of tape used, there may be times when the indication is not correct.

using Super VHS cassettes.

*By using the S-VHS ET function, it is possible to record and play back with S-VHS picture quality on VHS cassettes with this recorder.