JVC HR-S9700EK setup guide SET Input Mode, Locate Start Point, Engage Audio Dubbing, Start Dubbing

Audio Dubbing

53

Audio dubbing replaces the normal audio sound of a previously recorded tape with a new soundtrack.

ATTENTION:

Audio dubbing is not possible with a cassette recorded in EP mode.

	.DUB
LAY AUSE	8
	A

13

2

STOP

AUDIO

Normal audio track

Video/Hi-Fi audio track

Pre-recorded tape

Audio-dubbed tape

	CD Player, etc.
	CD Player, etc.
Mixer	Audio mixer
output
	Original sound
	AUDIO OUT

NOTES:

●When monitoring the sound during Audio Dubbing, the normal soundtrack is automatically selected. If you wish to hear the mixed sound (Hi-Fi + Normal soundtracks), press AUDIO to select " + (L+R) + NORM" (☞ pg. 35).

●Audio dubbing stops automatically when the counter reaches "0:00:00", and the recorder enters the Play mode. Check the counter reading before dubbing.

●Audio dubbing is also possible using the rear panel AV1 (L-1) IN/ OUT or AV2 (L-2) IN/DECODER connector. When using these connectors, make sure to select the correct input mode in step 2.

●Audio dubbing cannot be performed on a cassette that has had its record safety tab removed.

●When playing back an audio-dubbed tape, press AUDIO to select the soundtrack you wish to hear (☞ pg. 35).

MAKE CONNECTIONS

1 Connect an audio component to the AUDIO L + R connectors on the recorder's front panel.

●When connecting monaural equipment, use only the recorder's AUDIO L connector.

	SET INPUT MODE
	Press AUX and/or PR so that "F-1" or "S-1" appears in
2 place of a channel number.
	LOCATE START POINT
	Press PLAY to start playback of the tape in your
	recorder, and press PAUSE when you find the point
3 where you want to start dubbing.
4	ENGAGE AUDIO DUBBING
	Press A. DUB.
	● It is possible to take the original sound recorded on
	the tape in your recorder and mix it with other
	sounds from a microphone, CD player etc. To
	perform this audio dubbing with audio mixing,
	connect as in the diagram on the left.
	● Your recorder enters the Audio Dubbing Pause mode.
	(" " blinks, " " and " " light up on the front display
	panel.)
	● To perform audio dubbing with audio mixing, press
	AUDIO to select " + (L+R)" at this point.
	* Audio dubbing with audio mixing is not possible if
	you're using a monaural audio component, or if
	you don't have an audio mixer.
	START DUBBING
	Engage the audio component's Play mode, then press
	PLAY to start the tape in your recorder. Audio dubbing
5 begins at this point.

●"" blinks and "" is displayed on the front display panel.

●To stop dubbing temporarily, press PAUSE. Press PLAY to resume dubbing.

END AUDIO DUBBING

6 Press STOP to stop the tape in your recorder, and engage the audio component's Stop mode.