JVC 1204MNH-SW-VE, LPT0976-001B manual Connecting/Using a Decoder, Programme

		SYSTEM CONNECTIONS EN 77
Connecting To A Dolby Digital Decoder		When you can’t switch the audio channel of a bilingual
		programme
Or An Amplifier With Built-in DTS		When the unit is connected with a digital audio device using an
		optional optical cable and ADIGITAL AUDIO OUTB is set to
		ADOLBY DIGITAL/PCMB, it is not possible to switch the audio
These instructions enable you to connect your unit to a Dolby		channel of a bilingual programme recorded on a DVD-RAM or
Digital Decoder or an amplifier with built-in DTS.		DVD-RW (VR mode) disc. In this case, perform the following steps
		using the remote control to switch ADIGITAL AUDIO OUTB from
		ADOLBY DIGITAL/PCMB to APCM ONLYB.
		A Press SET UP to access the Main Menu screen.
		B Press DE to select ADVD VIDEO SET UPB, then press G.
		C Press DE to select AAUDIO OUTPUTB, then press G.
		D Press FG to select ADIGITAL AUDIO OUTB, then press
		ENTER.
		E Press FG to select APCM ONLYB, then press ENTER.
		(A pg. 78)
		F Press SET UP to complete the setting.
Dolby Digital Decoder or		G Press AUDIO to select the desired audio channel.
amplifier with built-in DTS
	To DIGITAL AUDIO input	Connecting/Using A Decoder
Coaxial cable	Optical cable	(HDD & DVD Deck Only)
(not supplied)	(not supplied)	The [L-2 IN/DECODER] connector can be used as an input
To [DIGITAL AUDIO	To [DIGITAL AUDIO	connector for an external decoder (descrambler). Simply connect a
		decoder and you can enjoy a variety of programming that is
OUT (COAXIAL)]	OUT (OPTICAL)]
		available through scrambled channels.

Rear of unit

Note for connection:

Remove the protection cap from the optical cable.

Decoder

TV

TV aerial cable

[L-1 IN/OUT]

[L-2 IN/DECODER]

1Connect the unit and a Dolby Digital Decoder or an amplifier with built-in DTS using either an optional optical cable or an optional coaxial cable.

NOTES:

●For Dolby Digital sound, set ADIGITAL AUDIO OUTB to ADOLBY DIGITAL/PCMB. (A pg. 78)

●For DTS sound, set ADIGITAL AUDIO OUTB to ASTREAM/PCMB. (A pg. 78)

CAUTIONS:

●This unit has a dynamic range of more than 110 dB with regards to its Hi-Fi audio capability. It is recommended that you check the maximum level if you are going to listen to the Hi-Fi audio signals through a stereo amplifier. A sudden surge in the input level to the speakers may damage them.

●Some speakers and televisions are specially shielded to prevent television interference. If both are of the non-shielded type, do not place the speakers adjacent to the TV set as this can adversely affect the playback picture.

RF cable (supplied)

1Set AL-2 SELECTB to ADECODERB. (A pg. 72)

2Connect your unit’s [L-2 IN/DECODER] connector to the decoder’s 21-pin SCART connector using a 21-pin SCART cable.

3Perform the procedure as described in AWhen Receiving A Scrambled Broadcast (HDD & DVD Deck Only)B (A pg. 85).