JVC 1204MNH-SW-VE Watch the images on VHS deck in the Progressive, Scan mode via component video

SUBSIDIARY SETTINGS EN 89

	Scan Mode Set				1 Press HDD or DVD so that the HDD or DVD lamp lights up on
					the unit.
					2 Press PROGRESSIVE SCAN for 3 or more seconds.
If you connect the unit and TV with Component Video Connection
					● Video output indicator (q) lights on the front display panel if
(A pg. 16), you can select the scan mode from two modes:
					Progressive scan mode has been established. (A pg. 12)
Interlaced scan mode which is used in the conventional TV
					● Each press of PROGRESSIVE SCAN for 3 or more seconds
system, and Progressive scan mode which enables reproduction
					switches the scan mode.
of higher-quality images.
					NOTES:
8 Interlaced scan
					● When the progressive mode is set, be sure to set AL-1 OUTPUTB
In the conventional video system, a picture is shown on the display
					to ACOMPONENTB (A pg. 72). Progressive scan is output only
monitor in two halves. The Interlaced scan system places lines of
					from [COMPONENT VIDEO OUT] connector.
the second half of the picture in-between lines of the first half of the
					● Interlaced scan mode is the setting at your purchase.
picture.
					● Interlaced scan mode might be suitable depending on video
8 Progressive scan
					material.
Progressive scan displays all the horizontal lines of a picture at					● Scan mode cannot be set while menu screen is displayed.
one time, as a single frame. This system can convert the interlaced					● When the Progressive scan mode is engaged, no video signal is
video from DVD into progressive format for connection to a					output from [L-1 IN/OUT] connector.
progressive display. It dramatically increases the vertical
					Watch the images on VHS deck in the Progressive
resolution.
					scan mode via component video
					1 Press HDD or DVD so that the HDD or DVD lamp lights up on
ATTENTION:
Your TV needs to be compatible with PAL Progressive.					the unit.
					2 Set AL-1 OUTPUTB to ACOMPONENTB (A pg. 72), and the
● Turn on the unit.					Progressive-compatibleTV to its component input mode.
					3 Press PROGRESSIVE SCAN for 3 or more seconds.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/SAT/DVD switch to DVD.					● The video output indicator q lights up on the front display
					panel.
			CABLE/SAT		4 Press VHS so that the VHS lamp lights up on the unit, then
			TV	DVD	press PROGRESSIVE SCAN.
		HDD			● ACOMP OFFB is displayed on the front display panel. It will be
			DVD		displayed for 5 seconds.
		VHS
					5 Press PROGRESSIVE SCAN again within 5 seconds.
					● ACOMP ONB is displayed on the front display panel and q
					lights up on the front display panel.
					● The VHS progressive scan image will then be outputted from
					the [COMPONENT VIDEO OUT (Y/PB/PR)] connectors.
					NOTES:
					● Be sure to engage the HDD or DVD deck in stop mode.
					● It is possible to watch in interlace mode through the component
					video connection (AL-1 OUTPUTB set to ACOMPONENTB)
					simply by pressing PROGRESSIVE SCAN to switch to ACOMP
					ONB. However, q will not light up on the front display panel as
					the image outputted is not in progressive mode.

PROGRESSIVE SCAN