22 EN SAT CONTROL SET
Satellite Receiver Control Setting | The following procedure is required if you receive satellite |
channels through a satellite receiver. Approximately 20 seconds | |
(HDD & DVD Deck Only) | before the atimer programming (A pg. 49) or Manual |
Timer programming (A pg. 51) starts, the unit sets its input mode | |
| to |
| |
| using the provided Satellite Controller. |
Satellite receiver
Installing Satellite Controller
| Satellite Controller | |
Your unit | (provided) | |
(suggested locations) | ||
| ||
| Transmitter | |
Satellite receiver |
|
Satellite Controller (supplied) | |
| (supplied) |
1Place the Satellite Controller so that the path between its transmitter and the satellite receiver’s remote sensor is unobstructed.
2Fix securely using the adhesive strip attached on the back of the Satellite Controller.
3Be sure to connect the unit’s
NOTE:
When connecting your satellite receiver, refer to its instruction manual.
4Connect the Satellite Controller to the [SAT CONTROL] connector on the rear panel.
Setting Satellite Receiver’s Brand And Channel
After installation, set the satellite receiver’s brand and channel correctly; otherwise, the Satellite Controller cannot work correctly.
●Turn on the unit.
●Turn on the TV and select the AV mode.
●Slide the TV/CABLE/SAT/DVD switch to DVD.
1Turn on the satellite receiver’s power.
2Press HDD or DVD so that the HDD or DVD lamp lights up on the unit.
| 3 | Press SET UP to access the Main Menu screen. |
| |
| 4 | Press DE to select AINITIAL SET UPB, then press G. | ||
To [SAT CONTROL] | 5 Press DE to select ATUNER | DVD VIDEO SET UP HDD/DVD SET UP | FUNCTION SET UP INITIAL SET UP | |
| SETB, then press G. | |||
To |
| TUNER SETCLOCK SET |
| |
DECODER] | 6 Press FGDE to select ASAT | AUTO CH SET | MANUAL CH SET | |
|
| CONTROL SETB, then press |
|
|
|
| ENTER. | SAT CONTROL SET | GUIDE PROG SET |
7 Press FG to select ABRANDB, |
|
| 11 12 13 |
|
|
| |
then press ENTER. | SET UP | ENTER | PRESS [SET UP] TO EXIT |
| SELECT WITH @ THEN PRESS [ENTER] |
8 | EXITSELECT |
Press FG to select the brand | |
Back of unit | code from the list on page 23, then press ENTER. |
● If the unit is in playback or recording mode, you cannot set the | |
CABLE/SAT | brand code. |
TV | DVD |
HDD | DVD |
|
9Press FG to select APROGRAMMEB, then press ENTER.
10Press FG to select one of the channel positions on the satellite receiver, then press ENTER.
●You can select the channel position between 1 to 999.
11 Press FG to select ATESTB, then press ENTER. The unit enters the Test mode.
ENTER
rtwe
INITIAL SET UP > SAT CONTROL SET
BRAND | 73 |
PROGRAMME | 12 |
| TEST |
SET UP | ENTER SELECT WITH @ THEN PRESS [ENTER] |
EXIT | PRESS [SET UP] TO EXIT |
SELECT |
SET UP
