Cards

Cards have Run Out

vReplenish the cards.
vThe card hopper is able to store up to about 100 cards with a
thickness of 0.76 mm.
Cautions:
vGet ready cards that are designated by the authorized dealer.
vIf the security lock is on, deactivate it. After work is complete,
activate the security lock again.
vDo not touch the printing surface of the card. Touching it may cause
printing errors. Put on the supplied gloves when handling the cards.
vTo prevent card jams from occurring, limit the number of cards
stored in the card hopper at any time to about 100 pieces regardless
of the card thickness.
vWhen using new cards, set them after making sure that they are not
adhered to each other due to static.
vAlign the cards before setting them in the printer. Otherwise, the card
hopper cover may not close properly, and this may damage the
printer.
vPrinting the card on the side with the magnetic stripe may cause
printing errors or damage to the card’s functions. If you want to do
so, please consult our authorized dealers in advance.
vTo set cards with both functions (magnetic stripe and contact IC),
follow the procedure for setting the contact IC card.
1Set the card hopper knob to [OPEN]
.
2Lift to remove the card hopper cover
.
3Align the orientation of the cards, and set them in the printer
mMagnetic stripe cards
vSet the card with the magnetic stripe facing upward and toward
the printer, or facing downward and toward you.
.
mISO contact IC cards
vSet the card with the Contact IC terminal facing upward and
toward the rear of the printer, or downward and toward the rear of
the printer.
vFor single-sided printers, set the cards with the IC terminal facing
down and toward the rear of the printer.
.
4Install the card hopper cover, and set the card hopper knob to
[LOCK]
.
Replacement
31