Ink Run Out B2
.
vInk ribbon has run out.
"Replace with a new one." (A page 32)
Hardware 44
.
vA hardware failure has occurred on the printer.
Turn off and on the power again. If the same problem recurs, turn off
the power and consult our authorized dealers.
MG Mechanical AB
.
vAn error has occurred in the mechanical component of the magnetic
encoder.
Turn off and on the power again. If the same problem recurs, turn off
the power and consult our authorized dealers.
MG Hardware AC
.
vA hardware failure has occurred on the magnetic encoder.
Turn off and on the power again. If the same problem recurs, turn off
the power and consult our authorized dealers.
Cam Error C1
.
vA heating roller operation error has occurred.
Turn off and on the power again. If the same problem recurs, turn off
the power and consult our authorized dealers.
HR Overheat C2
.
vThe temperature of the bend remedy heating roller or retransfer
heating roller is too high.
Turn off and on the power again. If the same problem recurs, turn off
the power and consult our authorized dealers.
Hardware D8
.
vA hardware error has occurred during initialization.
Turn off and on the power again. If the same problem recurs, turn off
the power and consult our authorized dealers.
TR Overheat F0
.
vThe temperature of the retransfer heating roller is too high.
Turn off and on the power again. If the same problem recurs, turn off
the power and consult our authorized dealers.
TR Heater F1
.
vThe retransfer heating roller is faulty.
Turn off and on the power again. If the same problem recurs, turn off
the power and consult our authorized dealers.
TR Thermister F2
.
vThe retransfer heating roller thermistor is faulty.
Turn off and on the power again. If the same problem recurs, turn off
the power and consult our authorized dealers.
RR Overheat F3
.
vThe temperature of the bend remedy heating roller is too high.
Turn off and on the power again. If the same problem recurs, turn off
the power and consult our authorized dealers.
RR Heater F4
.
vThe bend remedy unit is faulty.
Turn off and on the power again. If the same problem recurs, turn off
the power and consult our authorized dealers.
RR Thermister F5
.
vThe bend remedy heating roller thermistor is faulty.
Turn off and on the power again. If the same problem recurs, turn off
the power and consult our authorized dealers.
Overcool F6
.
vThe operating ambient temperature of the printer is too low.
Check the temperature. If the same problem recurs within the range
of operating ambient temperature, turn off the power and consult our
authorized dealers.
Head Overheat F8
.
vThe temperature of the thermal head is too high.
Turn off and on the power again. If the same problem recurs, turn off
the power and consult our authorized dealers.
Power Intrpt C3
.
vAn instantaneous interruption is detected.
Turn off and on the power again. If the same problem recurs, turn off
the power and consult our authorized dealers.
Troubleshooting
45