6Press KNB to reset the printer
.
Memo:
vTo avoid printing errors, it is recommended that you forward by one
or two images after installing the ink ribbon cassette or retransfer film
cassette.
"Initializing printer when installing the cassette" (A page 22)
Retransfer Film

Retransfer Film has Run Out

vReplace with a new retransfer film.
Cautions:
vIf the security lock is on, deactivate it. After work is complete,
activate the security lock again.
vStand the cassette on a flat surface as illustrated in the diagram.
Avoid doing so on the floor as dust attached to it may cause printing
errors.
.
vDo not touch the retransfer face (the side that faces outward when
installed) with your hand. Touching it may cause printing errors. Put
on the supplied gloves when handling the retransfer film.
vThe cassette is heavy when the retransfer film is loaded. To prevent
the cassette from dropping during handling, make sure to hold it with
both hands.
vWhen installing a used retransfer film, align the unused side of the
film with the arrow indicated on the label of the cassette. Improper
alignment may result in errors, or the print may turn out light.
vWhen installing a new film, make sure that at least three black lines
are wound onto the take-up side. Insufficient winding may cause the
printer to malfunction.
vDo not perform any work on the printer door. Do not place heavy
objects or apply load on the printer. Doing so may damage it.
vDuring replacement, clean the four bobbin holders on the printer. If
burrs produced by friction with the bobbins are attached to the
bobbin holders, they may fall onto the card, ink ribbon, or retransfer
film, causing printing errors.
"Cleaning the bobbin holders" (A page 40)
1Open the printer door
.
2Press and hold down the cassette button, and pull out the retransfer
film cassette (on the left) to remove the retransfer film
.
Replacement
33