[Printing area] Dialog Box

Settings related to the printing area using the peel-off ink or areas not
to be printed using all YMCKUV inks.
.
.
Direction of card
movement
H
W
Y=0
X=0 About X=87.5
About Y=56.0
mRectangular region
Printing area information.
mX
X coordinate that indicates the start of the area. (Unit: mm).
mY
Y coordinate that indicates the start of the area. (Unit: mm).
mW
Width of the printing area. (Unit: mm).
mH
Height of the printing area. (Unit: mm).
mInk
Ink valid for the printing area.
v1. Peeloff:
Area for printing using the peel-off ink.
v2. YMCK:
Area not to be printed using all YMCKUV inks.
mSide
The side of the card for which the printing area is valid.
v1. Front:
Front side
v2. Back:
Back side
m[Add] button
Registers the input data. You can enter up to 8 input data.
m[Delete] button
Deletes the information selected in the list.
m[Delete All] button
Deletes all registered information.
mPeeloff ink energy
Print density of the peel-off ink.
Do not alter the following values.
vE1: 225
vE2: 160
vE3: 160
mSetting values
The following requirements must be satisfied.
.
E1
E2
E3
>
=
>
=
E1
E2
E3
The following values are recommended when peel-off printing is
performed on the ISO magnetic stripe area of the card.
XY W H Ink Side
0 0 87.46 17.86 1. Peeloff 1. Front
0 0 87.46 21.42 2. YMCK 1. Front
Cautions:
vThe input value of the textbox may differ from the value of the
“Printing area information” portion by an accidental error in
calculation.
Memo:
vThe printing start position displayed on the application software may
not coincide with the X=0, Y=0 position above.
About 1 mm from the edge of the image is not printed on the card.
"The edge of the image is not printed" (A page 123)
Setup
89