JVC CA-NXCDR7R, LVT0749-003A Turning On the Power, Saving the Power Consumption while On Standby

Continued

Before operating the unit any further, first set the clock built in this unit (see page 48).

Turning On the Power

To turn on the unit without playing, press so that the STANDBY/ON lamp on the unit lights green, and the CDR lamps light.

UNFINALIZE DISC PITCH S S O [ e s o ] dB U SC

To turn off the unit (on standby), press again so that the STANDBY/ON lamp lights red, and the CDR lamps go off.

•When the power is off (on standby), clock time appears in the main display—initial setting when shipped from the factory (see “Saving the Power Consumption while On Standby” below).

•A little power is always consumed even while the unit is in standby mode.

To switch off the power supply completely, unplug the

AC power cord from the AC outlet.

Saving the Power Consumption while On Standby

You can save the power consumption while the unit is turned off by erasing the clock display.

To save the power consumption while on standby, press DISPLAY on the remote control while the unit is turned off (on standby—while the STANDBY/ON lamp lights red).

UNFINALIZE DISC PITCH SLEEP RDSEON TA News Info REC LEVEL dB UNFINALIZE DISC

•Power consumption during standby is reduced (see “Specifications” on page 57) and the clock will not be shown while the unit is turned off (on standby).

To cancel the power consumption saving mode, press DISPLAY again while the unit is turned off (on standby).

When you unplug the AC power cord or if a power failure occurs

The power consumption saving mode (“DISPLAY OFF”) will be canceled.

Selecting the Sources and Starting Play

To select 3-CD Changer as the source, press CD 3/ 8. The unit automatically turns on. (Play starts if a CD is on the last selected disc tray.)

To stop play, press 7.

• For more detailed operations, see pages 23 to 28.

To select CD Recorder as the source, press CDR 3/ 8. The unit automatically turns on. (Play starts if a disc is in CD Recorder.)

To stop play, press 7.

• For more detailed operations, see pages 29 and 30.

To select the tuner and external component as the

source, press SOURCE. The unit automatically turns on.

•Each time you press the button, the source changes as follows:

FM AM LINE

FM: To listen to an FM broadcast.

AM: To listen to an AM (MW/LW) broadcast.

LINE: To play back the external component connected to the LINE IN jacks on the rear panel.

•For operating FM/AM (MW/LW), pages 17 to 22.

•For operating the external components, refer to its manual.

To adjust the input level through the LINE IN jacks

If the sound from the component connected to the LINE IN jacks is too loud or is not loud enough when changing the source to “LINE” from another source (without adjusting the volume level), you can change the input level through the LINE IN jacks.

On the unit ONLY:

When the source is “LINE,” press and hold SET (inside the sliding panel) repeatedly to select your desired level.

•Each time you press and hold the button, the input level changes—“LEVEL 1,” “LEVEL 2,” and “LEVEL 3.”

LEVEL 1: Normally select this. (Initial setting when shipped from the factory.)

LEVEL 2: Select this when the sound is not loud enough.

LEVEL 3: Select this when the sound is too loud.

– 14 –