JVC CA-NXCDR7R manual Selecting the Sound Modes, Creating Your Own Sound Modes -MANUAL Modes

Selecting the Sound Modes

You can select one of the 5 preset sound modes and 2 manual modes.

•You can use this effect only for playback, but not for recording.

On the remote control ONLY:

Press SOUND repeatedly until the sound mode you want appears in the main display.

The SOUND indicator also lights on the display.

•Each time you press the button, the sound modes change as follows:

CD

			NORMAL
1	2	3	SPEED

REC LEVEL dB

	D.CLUB	HALL	STADIUM	ROCK
FLAT(Canceled)				POP

SET=MANUAL2 ? SET=MANUAL1 ?

D. (Dance) CLUB: Increases resonance and bass.*

HALL:Adds depth and brilliance to the sound.*

STADIUM: Adds clarity and spreads the sound, like in an outdoor stadium.*

ROCK: Boosts low and high frequency. Good for acoustic music.

POP:Good for vocal music.

SET=MANUAL1 ?: Your individual mode stored in memory without surround elements.**

SET=MANUAL2 ?: Your individual mode stored in memory with surround elements.**

FLAT:Cancels the sound mode.

*Surround elements are added to create a being-there feeling. **See “Creating Your Own Sound Modes—MANUAL Modes” on

the right column.

To check the sound mode currently selected, press

SOUND once while the SOUND indicator is lit.

The currently selected sound mode appears in the main display.

Creating Your Own Sound Modes —MANUAL Modes

You can create and store your own sound modes.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the remote control ONLY:

1 Press SOUND repeatedly until “SET =MANUAL1 ?” or “SET =MANUAL2 ?” appears in the main display.

The SOUND indicator also lights on the display.

Ex.: When selecting “SET=MANUAL1 ?”

SET=MANUAL1 ?: Select this when you want to store your individual mode without surround elements.

SET=MANUAL2 ?: Select this when you want to store your individual mode with surround elements.

2 Press SET.

3 Adjust the equalizer pattern.

1)Press ¡/ ¢or 4 / 1to select the frequency range to adjust (LOW, MIDDLE, HIGH).

2)Press =(+10) or +(10) to adjust the level (–3 to +3) of the selected frequency range.

Ex.: When adjusting middle frequency range

3)Repeat steps 1) and 2) to adjust the level of the other frequency ranges.

4 Press SET again (or wait until the above indication disappears).

“MEMORY” appears in the main display and the equalizer pattern you have created is stored in memory.

To use your own sound mode

See “Selecting the Sound Modes” on the left column.

– 16 –