JVC LVT0749-003A, CA-NXCDR7R manual Connecting Speakers, To connect an outdoor AM MW/LW antenna

AM (MW/LW) antenna

AM (MW/LW) loop antenna

(supplied)

3

1

2

Vinyl-covered wire

(not supplied)

1 If cords are covered with insulation, twist the core of

the cord at the end of each cord, then remove the insulation.

2 Connect the AM (MW/LW) loop antenna to the AM

LOOP terminals as illustrated.

3 Turn the AM (MW/LW) loop antenna until you have the best reception.

To connect an outdoor AM (MW/LW) antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. Keep the AM (MW/LW) loop antenna connected.

For better reception of both FM and AM (MW/LW)

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

Connecting Speakers

You can connect the speakers using the speaker cords.

1
2	3	4
Red		Red
Black		Black
		Speaker
		cord
	Right	Left
	speaker	speaker

1 If cords are covered with insulation, twist the core of the cord at the end of each cord, then remove the insulation.

2 Hold the clamp of the speaker terminal.

3 Insert the end of the speaker cord to the terminal.

Match the polarity of the speaker terminals: Red (+) to red (+) and black (–) to black (–).

4 Release the finger from the clamp.

Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

– 9 –