JVC CA-NXCDR7R manual Tuning into a Station, Presetting Stations, To change the FM reception mode

Continued

Tuning into a Station

1 Press SOURCE repeatedly until FM or AM (MW/ LW) is selected.

The unit automatically turns on and tunes into the previously received station (either FM or AM—MW/ LW).

•Each time you press the button, the source changes as follows:

FM AM LINE

2 Tune into a station.

On the remote control:

Press and hold ¡/ ¢ or 4/ 1until the station frequencies start changing in the main display.

On the unit:

Press and hold ¢ or 4until the station frequencies start changing in the main display.

•¡ / ¢(¢): to increase the frequencies.

•4 / 1(4): to decrease the frequencies.

The unit starts searching stations and stops when a station of sufficient signal strength is tuned in.

•If an FM stereo program is received, the STEREO indicator lights on the display.

To stop during searching, press the same button you have pressed in step 2 above.

When you press the button briefly and repeatedly in step 2

The frequency changes step by step.

To change the FM reception mode

On the remote control ONLY:

When an FM stereo broadcast is hard to receive or noisy, press FM/PLAY MODE so that “MONO” appears in the main display.

The MONO indicator also lights on the display. Reception improves.

UNFINALIZE DISC PITCH SLEEP RDSEON [ TA News Info ] REC LEVEL dB UNFINALIZE DISC

MONO

To restore the stereo effect, press FM/PLAY MODE again so that “AUTO” appears in the main display.

In this stereo mode, you can hear stereo sounds when a program is broadcast in stereo.

UNFINALIZE DISC PITCH SLEEP RDSEON [ TA News Info ] REC LEVEL dB UNFINALIZE DISC

Presetting Stations

You can preset 30 FM and 15 AM (MW/LW) stations— using either automatic presetting method or manual presetting method.

•You cannot store FM reception mode separately for each preset station.

In some cases, test frequencies have been already memorized for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations you want into memory by following the presetting method.

To preset stations automatically—Automatic Presetting

You need to preset stations separately for the FM and AM bands.

On the remote control ONLY:

1 Press SOURCE repeatedly until FM or AM (MW/ LW) is selected.

2 Press and hold AUTO PRESET for more than 4 seconds.

Automatic Presetting starts and local stations with strong signals are searched and stored in memory automatically.

When automatic presetting is over, the station stored in preset number 1 is tuned in.

3 Repeat steps 1 and 2 to store stations of the other band—FM or AM (MW/LW).

UNFINALIZE DISC PITCH SLEEP RDSEON [ TA News Info ] REC LEVEL dB UNFINALIZE DISC

STEREO

When you cannot store stations you want automatically

Stations with weak signals cannot be detected with this automatic presetting method. To store such a station, use the manual presetting method on page 19.

– 18 –