JVC CA-NXCDR7R manual Sound SYNC. REC? Canceled, REC indicator flashes on the display for a while

Continued

Recording the External Components —Sound Synchronized Recording

With this recording method, you can start recording automatically when the source sound comes into this unit through the LINE IN jacks or the LINE DIGITAL IN terminal.

Observe the following when recording from external component through the LINE DIGITAL IN terminal.

•Make sure that it is connected correctly.

•Make sure to turn it on, and leave it turned on while recording.

•Sound Synchronized Recording will stop automatically if no sound comes in for more than 30 seconds.

On the unit ONLY:

Before recording, adjust the recording input level if necessary.

See “To adjust the recording input level” on page 35.

1 Insert a recordable CD-R or CD-RW on the CDR disc tray.

2 Press SOURCE repeatedly until “LINE” appears in the main display.

3 Press LINE REC SELECT (inside the sliding panel) repeatedly to select either “ANALOG IN” or “DIGITAL IN.”

•ANALOG IN: Select this to record sounds through the LINE IN jacks. The ANALOG indicator lights on the display (analog-to-digital recording).

•DIGITAL IN: Select this to record sounds through the LINE DIGITAL IN terminal. The DIGITAL indicator lights on the display (digital-to-digital recording).

4 Press REC MODE (inside the sliding panel) to select “SOUND SYNC. REC?”

• Each time you press the button, Sound Synchronized Recording turns on and off.

	AUTO TRACK
	NORMAL
1 2 3	SPEED		CD-RW
	REC LEVEL dB	UNFINALIZE DISC

SOUND SYNC. REC? Canceled

5 Press REC START (inside the sliding panel).

The REC indicator flashes on the display for a while.

	AUTO TRACK
1 2 3			CD-RW
		dB REC
	REC LEVEL		UNFINALIZE DISC

Ex.: When “ANALOG IN” is selected in step 3

6 Start playback on the selected external component.

Recording starts automatically when the sound signals come in.

			AUTO TRACK
			NORMAL
1	2	3	SPEED	CD-RW
			REC LEVEL	REC UNFINALIZE DISC

Remaining time in the

CD-R/CD-RW

To confirm the recording contents, see “To change the display information while recording” on page 35.

To stop recording, press 7. “STOP DUBBING” flashes for a while.

•Both 3-CD Changer and CD Recorder stop automatically.

To remove the recorded disc, press 0CDR. “FINALIZE ?” flashes in the main display for a while.

•If you do finalize the disc, press FINALIZE. Remember once you finalize a CD-R, no further recording can be made on the disc. (For more details, see “Finalizing a Disc—CD-R/CD-RW” on page 41.)

•If you do not finalize the disc, press 0 CDR again.

If Sound Synchronized Recording do not work correctly when “ANALOG IN” is selected as the input terminal

Use the Standard Recording method (see page 34).

Sound Synchronized Recording starts automatically when this unit detects sound signals coming in. This means that, if sound signal is too weak for this unit to detect, Sound Synchronized Recording will not start (or will stop even while the source is being played).

When recording from a DAT deck using Sound

Synchronized Recording

Two track marks may be recorded at the beginning of the recording. If this occurs, record a skip mark so that either track mark will be ignored during playback. (See page 45.)

– 40 –