JVC CA-NXCDR7R, LVT0749-003A Setting the Clock, Using Recording Timer, To adjust the clock again

Continued

There are three timers available—Recording Timer, Daily Timer, and Sleep Timer.

Before using these timers, you need to set the clock built in the unit.

•In addition to these three timers, you can also use Auto Power Off to shut off the power automatically.

Setting the Clock

You can set the clock whether the unit is turned on or off (on standby).

•If you have activated the power consumption saving mode (“DISPLAY OFF”), you cannot adjust the clock while the unit is turned off (on standby). For details, see page 14.

On remote control ONLY:

1 Press CLOCK/TIMER.

The hour digit in the main display starts flashing.

2 Press ¡/ ¢or 4/ 1to adjust the hour, then

press SET.

•If you want to correct the hour after pressing SET, press CANCEL.

The hour digit starts flashing again.

3 Press ¡/ ¢or 4/ 1to adjust the minute, then press SET.

The built-in clock starts working.

To adjust the clock again

Once you have adjusted the clock, you need to press CLOCK/TIMER repeatedly until the clock setting screen appears in the main display (the hour digit starts flashing).

When you unplug the AC power cord or if a power failure occurs

The clock will be reset to “0:00” in about one minute.

Using Recording Timer

With Recording Timer, you can make an unattended recording.

•You can set Recording Timer whether the unit is turned on or off (on standby).

•To correct a misentry any time during the process, press

CANCEL.

•To cancel the setting any time during the process, press

CLOCK/TIMER.

How Recording Timer actually works

The unit automatically turns on about 3 minutes before timer recording starts, then turns off the volume and starts recording on CD Recorder when the timer on-time comes. When the timer off-time comes, the unit automatically turns off (stands by).

•Recording Timer works only once, but the timer settings remain stored in memory.

Before you start....

•Make sure that a recordable CD-R or CD-RW is inserted on the CDR disc tray. If not, insert a recordable CD-R or CD-RW.

•When you want to record from the external component (“LINE”), make sure the input you want to use is currently selected—either “ANALOG IN” or “DIGITAL IN.” (See page 34 for more details.)

On remote control ONLY:

1 Press CLOCK/TIMER repeatedly until the Recording Timer on-time setting screen appears in the main display.

The (Timer) indicator lights and the REC (Recording Timer) indicator starts flashing on the display.

•Each time you press the button, the timer mode changes as follows:

REC

REC = ON 0:00 = DAILY = ON 0:00 = 0:00 = Canceled =(back to the beginning)

* “0:00” is the initial setting time at the factory.

To be continued

– 48 –