JVC LVT1055-001A Tuning in to a preset station, Selecting a preset station directly, 92.5 MHz

	2 Tune in to a station (in this example,
ENGLISH
		higher frequencies
	of 92.5 MHz).
		To tune in to stations of
		To tune in to stations of
		lower frequencies

3 Press and hold the number button (in this example, 1) for more than 2 seconds.

1

The display pattern automatically changes like the above pattern (see page 15). The preset number flashes for about 5 seconds, then the previous display pattern resumes.

4 Repeat the above procedure to store other stations into other preset numbers.

Notes:

•A previously preset station is erased when a new station is stored in the same preset number.

•Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.

Tuning in to a preset station

You can easily tune in to a preset station. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on pages 13 and 14.

Selecting a preset station directly

1 Select the band (FM1 – 3, AM).

1Press SRC (source)

SRC

repeatedly to select the tuner.

2Press and hold SRC.

Each time you press and hold the button, the band changes.

FM1 FM2 FM3 AM

2 Select the number (1 – 6) for the preset station you want.

1 2 3 4 5 6

Note:

You can also use the 5(up) or ∞(down) button on the unit to select the next or previous preset stations. Each time you press the 5(up) or ∞(down) button, the next or previous preset station is tuned in.

When using the remote controller

1Press FM or AM.

• When selecting the FM bands,	FM
	DAB
press FM repeatedly until the
band you want is selected.	AM

2Press the number buttons (1 to 6) while holding SHIFT (S).

SHIFT	TOP		MENU
S	MENU
	1	2	3
		DISC +
		ENTER
	4	5	6

Note:

You can also use the PRESET (FOLDER) 5/ ∞ buttons for selecting a preset station.

14