JVC LVT1055-001A manual To erase entered characters, Sources Maximum number Characters

Assigning names to the sources

You can assign names to station frequencies, CDs (both in this unit and in the CD changer), and the external component.

After assigning a name, it will appears on the display when you select the source.

Sources	Maximum number of
	characters
Station frequencies	Up to 10 characters (up to
	30 station frequencies
	including both FM and
	AM)
CDs*	Up to 32 characters (up to
	40 discs)
External component	Up to 8 characters

*You can assign a name only to conventional CDs.

1 Select a source you want to assign a name to.

3 Select the character set you want while the first character position is flashing.

DISP

Each time you press the button,

Dthe character set changes as follows:

(A – Z: capital) (a – z: small)

(0 – 9: numbers, and symbols)

4 Select a character.

• About the available characters, see page 66.

ATT

5 Move the cursor to the next

(or previous) character position.

ENGLISH

SRC

When you select a source, the

power automatically comes on.

2 While pressing DISP (D), press and

hold SEL (select) for more than 2 seconds.

DISP

SEL

D

6 Repeat steps 3 to 5 until you finish entering the name.

7 Finish the procedure while the last selected character is flashing.

SEL

To erase entered characters

Insert spaces using the same procedure described above.

Ex.: When you select “DISC” as the source

Notes:

•When you try to assign a name to the 41st disc or to the 31st station frequency, “Name Full” appears and you cannot enter the text entry mode. In this case, delete unwanted names before assignment.

•When the CD changer is connected, you can assign names to CDs in the CD changer. These names can also be shown on the display if you insert the CDs in this unit.

57